Electrolux Tumble action washer Installation Instructions And Use And Care Manual

Tumble Action Washer Installation Instructions and Use and Care Guide Machine À Laver Par Culbutage Commerciale à encaissement automatique Instructions d’installation et Guide d’utilisation et d’entretien P/N 134777900 (0706) ...

these instructions. This will simplify the installation and ensure the washer is installed correctly and safely. Leave these instructions near the washer after installation for future reference. NOTE: The electrical service to the washer must conform with local codes and ordinances and the latest edition of the ...

grounding plug Do not under any circumstances cut, remove, or bypass the grounding prong from this plug. Do not use or mix liquid chlorine bleach with other household chemicals such as toilet cleaners, rust removers, acid or products containing ammonia. These mixtures can produce dangerous fume ...

conductor can result in a risk of electrical shock. Check with a licensed electrician if you are in doubt as to whether the appliance is properly grounded. 1. The washer MUST be grounded. In the event of malfunction or breakdown, grounding will reduce the risk of electrical shock by a ...

5 ROUGH-IN DIMENSIONS SIDE POWER CORD inch (cm) Ò Ñ 8 43/8 < > v ^ (11.2) (20.4) BACK UNDER COUNTER WATER INLETS inch (cm) 5 > 17 (43.2) < (Figure 1). ...

of the unit. 2. While in the carton carefully lay the washer on its back side. 3. Removethe styrofoam base. 4. Carefully return the washer to an upright position and remove the carton. 5. Carefully move the washer to within 4 feet (122cm) of the final location. 6. Remove the followin ...

a U shape on the end of the drain hose, with the hose pointed toward the drain. NOTE: If the drain hose is placed in a standpipe without forming a U shape, a siphoning action could occur. There must be an air gap around the drain hose. A snug hose fit can also cause a siphoning action. 6. Ca ...

Screws FIGURE 3 (1) Receiver Block Screw Spare Parts Compartment and Screw Coin Receiver Block FIGURE 4 FIGURE 5 FIGURE 6 NOTE: Black colored slots are closed off by block- out key. • Pull coin slide out of coin chute (see FIGURE 4). STEP 4 Turn coin slide upside down and remove screw that holds coin receiver block (see FIGURE 5). STEP 5 ...

Chute Cover Screws FIGURE 9 9 (2) Coin Sizing Block Screws Coin Sizing Block FIGURE 10 Change coin sizing block: • Remove two screws that hold upper coin chute cover. Remove cover (see FIGURE 9). • Remove two screws that hold coin sizing block to upper coin chute cover cover (see FIGURE 10). • Put new coin ...

2 1 76-6009-* TIMER MOTOR ASS’Y 3 1 76-1037 SWITCH & BRACKET SUB-ASS’Y 4 1 76-5014 DRIVE SELEEVE 5 1 76-2033 SLEEVE 6 1 00-8149 TORSION SPRING 7 3 00-7070 RETAINING RING 8 2 76-5013 DRIVE BUSHING 9 1 00-8003 SPRING 10 1 76-1036 RACTHET ARM & PAWL ASS’Y 11 1 76-5017 RACHET WHEEL 12 1 ...