Epson UB-E02 Technical Reference Manual

Chapter 5 Specifications The UB-E02 can be installed in the TM-series printers as an interface board to provide 10 Base-T/100 Base-TX communications. 5.1 Printer Connection The interface board can be installed in TM-series printers that support the universal interface board system. 5.2 Line Displ ...

Epson UB-E02 Please read this section carefully and store it in an accessible location. CAUTION: ❏ Be careful to avoid dropping conductive objects such as paper clips on the circuit board, as they could short circuit connections and cause damage fr ...

Epson UB-E02 down for more than 3 seconds when the printer is ready for printing. The version of the UB-E02 and its settings are printed. See “UB-E02 Status Sheet Printing” on page 7 of this chapter. Switch ...

Epson UB-E02 Chapter 5 Specifications Printer Connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-1 Line Display Connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-1 Features . . . . . . . . . . ...

Epson UB-E02 ❏ PDU support Get Request Get Next Request Set Request Get Response Trap ❏ Server port number 161 ❏ Trap sending port number 162 5.5.3.3 ENPC ❏ Protocol: UDP/IP ❏ UDP port number: 3289 ❏ Compatible packet types: Probe Initialize Query Setup Notify 5.5.4 Automatic IP Address Assignment ...

Epson UB-E02 1. Using the exclusive utility. 2. Using a browser 3. Using arp and ping commands (only to set IP address) 5.5.5.3 Setting with Exclusive utility Settings cannot be made by the specified application software when the ENPC protocol is used. A dedicated utility which can set miscellaneous w ...

Epson UB-E02 CAUTIONS ❏ This document shall apply only to the product(s) identified herein. ❏ No part of this document may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Seiko Epson ...

Epson UB-E02 Item Explanation Printer name Set the printer name. Model name Shows the printer model name. Printer ID Shows the printer ID. Printer type Shows the printer type. Version Shows the ROM version. ...

The table shows each item and its function. 3.2.1.1 Tool Menu Time-out setting Use Time-out setting to set the time-out for data transmission and reception. This can be set from 2 to 120 seconds. If the time-out exceeds the value set, a communication error occurs. Menu Sub Menus Explanation Device Setting Start the set ...

Epson UB-E02 5.4.3 External appearance and connector locations 5.5 Software Specifications 5.5.1 Basic Communications Protocols 5.5.2 Printing Communications Protocols 5.5.2.1 LP, LPR ❏ Remote printer name: aux ❏ Maximum simultaneous connections: 3 ❏ Number of connections that can print: 1 (other us ...

Epson UB-E02 the self test for the printer.) 2.8.1.1 A1. For TM-T90, TM-L90, TM-J2000, TM-J2100, TM-J7000, TM-J7100, TM-J7500, and TM-J7600, set the #25 pin reset signal of the Memory switch set to disabled. For other models, use the printer with the #3 ...