Toshiba Bar Code Printer Network Tool Operation Manual

Check [Repair], then click [Next]. ¾ When changing the installation setting, check [Modify]. ¾ When reinstalling all features by the previous setup, check [Repair]. ¾ When uninstalling all installed features, check [Remove]. 4. The screen which shows a progress bar appears. Clicking [Cancel] stops the operation. 5. The ...

Toshiba Bar Code Printer There are four major setting items: [Position], [Density], [Ribbon], and [Sensor]. z Position Makes setting for positional relationship between paper and the printer. Î ‘Positional Adjustment Using [Adjust] Tab’ z Density Selects a fine adjustment value for the print density. z R ...

[Save the result] and [OK] buttons are enabled. To save the download result, click [Save the result], and to show the Main screen without saving the result, click [OK]. ¾ For details of files to be saved by [Save the result], please refer to ‘Download Result File’. ...

Toshiba Bar Code Printer installed features are marked with a check mark. Remove the check mark for the features you want to uninstall. Check the features you want to install. Click [Next] to start the modification. ¾ Removing all check marks and clicking [Next] display the right screen. Click [OK] to return to the [Select ...

Toshiba Bar Code Printer This section explains each screen. [Obtaining printer information] Screen This screen appears while the printer is obtaining printer information. [Printer Selection] Screen This screen appears when the downloader is started alone or when no printer information has been recorded. You will list a printer by clickin ...

Toshiba Bar Code Printer Note: Opening several [Printer Monitor] screens can monitor several printers (1 printer/screen). It is preferable that a maximum of 10 screens be opened at the same time. Depending on the operational environment (especially under ...

Toshiba Bar Code Printer ¾ Assuming the label gap is 2 mm, the print stop position in strip issue mode is designed in a manner so that printing stops when the distance from the middle of the gap between labels to the end of the strip shaft is 4 mm. ¾ When this print stop position is not proper because the gap is more than 2 mm, the print stop p ...

Sets Sender information, destination address, sending conditions, and mail format. z Sender information ¾ [Mail Server] A name of a sender’s mail server is entered. (Up to 256 characters) This information is required for a protocol to send email. ¾ [User Name] A name of a sender is entered. (Up to 64 characters) This information is re ...

Toshiba Bar Code Printer This Installation Procedure guides you to install the Downloader only. When you want to use the Downloader only, install it following the instructions below. z Refer to the section ‘Installation Procedure (for the Administrator) – Full Installation of the Product‘ and follow Steps 1 ...

Toshiba Bar Code Printer 1. Click: [Start] – [All Programs] – [TOSHIBA TEC] – [TEC Barcode Network Tool] – [TEC Barcode Net Admin] to start the Surveillance Tool. 2. The [Login] screen appears. Click [User Mode]. 3. The icon appears in the task tray. Right-click it. 4. Select [TECNet View], and List View (Page 28) starts. ¾ When [Display the list at t ...