Frigidaire GLEQ2152EE - 27" Front-Load Electric Dryer Installation Instructions Manual

Instrucciones para la instalación Secadora ...

2 CONTENTS Pre-Installation Requirements..........................................................................................................................................2 Electrical Requirements..................................................................................................................................................3 Exhaust S ...

amp. maximum time delay fuse or circuit breaker. POWER SUPPLY - 3 wire, 120 volt single phase, 60 Hz, Alternating Current. POWER SUPPLY CORD - The dryer is equipped with a 120 volt 3-wire power cord. NEMA 10-30R NEMA 14-30R ELECTRICAL REQUIREMENTS ELECTRIC Dryer CIRCUIT - Individual 30 ...

SAME AS OTHER SIDE SAME AS OTHER SIDE SAME AS OTHER SIDE SAME AS OTHER SIDE (9.5 cm) (9.5 cm) (9.5 cm) (9.5 cm) (9.5 cm) 4 3/8" 4 3/8" 4 3/8" 4 3/8" 4 3/8" 5 7/8" 5 7/8" 5 7/8" 5 7/8" 5 7/8" 13 1/2" 13 1/2" 13 1/2" 13 1/2" 13 1/2" 3 3/4" 3 3/4" 3 3/4" 3 3/4" 3 3/4" 3 3/4" 3 3/4" 3 3/4" 3 3/4" 3 3/4" In installations where the exhaust sys ...

(387.1 sq. cm) 60 sq. inches (387.1 sq. cm) 0" (0 cm) 0" (0 cm) 0" (0 cm) 1" (2.54 cm) LOCATION OF YOUR DRYER DO NOT INSTALL YOUR DRYER: 1. In an area exposed to dripping water or outside weather conditions. 2. In an area where it will come in contact with curtains, drapes, or anything that will obstruct the flow of combustion a ...

28.75” to clear knobs 29.5” to clear door handle 49” to clear open door 13.5” 40.75” Center line height for rear, right, left vents 4.375” Side exhausts 27.0” 38” Gas supply pipe on rear of unit 2.375” Electrical supply on rear of unit 71.75” 27.0” 36.0” 48.5” To clear open door 28.5” Center line ...

(ONE FROM EACH HINGE FIRST) UNP UNP UNP UNP UNPACKING ACKING ACKING ACKING ACKING 1. Using the four shipping carton corner posts (two on each side), carefully lay the dryer on its left side and remove the foam shipping base. To prevent damage, do not use the control panel as a means to pick up or move the dryer. 2. Retu ...

opposite the hinges. Retain all parts for uses later, unless otherwise noted. (Figure 1) Note: Use care in removing plugs in not scratching paint on the front panel. Figure 2 2. Begin removing the four (4) screws that attach the hinge to the front panel. (Figure 2) For best results, start by ...

transition plugs out of transition ring and through lens. (Figure 8). Only required on doors with transition plugs. Figure 9 9. Flip door, lens side up, apply moderate pressure downward and rotate 180 degrees so ho ...

proper and safe electrical installation of your dryer. Failure to follow these instructions can create electrical shock and/ or a fire hazard. This appliance MUST be properly grounded. Electrical shock can result if the dryer is not properly grounded. Follow the instructi ...