Ryobi AP13AK Owner's Operation Manual

Specificatons Rules for Safe Operation Loose Parts List Operation Adjustment Maintenance Troubleshooting 1 1 2-4 4 5 6-9 10 11 PRODUCT SPECIFICATIONS Input No Load Speed Min Planing Length Max Planing Width Planing Height Depth Per Pass Feeding Speed Binder Weight 2000 watt 9000 R.P.M. 127 mm 318 mm 5 - 153 mm 3 mm 8m / min 48mm with ...

The purpose of safety rules is to attract your attention to possible dangers. The safety symbols and the explanations with them, require your careful attention and understanding. The safety warnings by themselves do not elimimate any danger. The instruction or warnings they give are not substitutes for proper accident prevention meas ...

Page 3 Power Switch Table Extention Depth Scale Hand Crank Stock Rollers Overload Switch Always wear eye protection when operating the machine. Check to make sure all holding screws are tight before starting machine. Always stop the motor and disconnect from power source before making any adjustments. Be sure all guards are in place ...

1) “C” Circlip ......................................................................................................................................... 4 pieces 2) Blade Setting Guide ..........................................................................................................................2 pieces 3) Blade Setting ...

The planer can be carried using the handles on either side of the frame. Make sure the table extensions are closed before moving the planer. MOUNTING THE PLANER ONTO THE WOOD BASE (Fig. 2a&2b) When the planer is not mounted on a planer stand, it is suggested that it be mounted onto two pieces of timber. This will ensure maximum sta ...

To adjust the depth of cut, turn the cutterhead- raising hand crank in the direction marked on top of the planer. The depth of cut adjustment can be read from the depth scale. The adjustment gradation is 2mm per revolution of the hand crank.(Fig. 5) Always start your work by making a light planing cut. The depth ...

To obtain a blade projection of 1.5mm, place the blade setting gauge (E) on the cutterhead with both guides resting firmly against the blade. (Fig. 8) Loosen the assembly by turning the 7 screws (A) clockwise with an open end wrench. When the blade is pressed to the required height by guides on the gauge, retighten the as ...

PARALLEL (Fig. 9~12) Plane a workpiece and measure thickness after the cut. If the thickness is not the same on both sides of the workpiece, perform the following action. Adjust the cutter shaft and the worktable so they are parallel. The tools used for checking are shown below . Please use hardwood to ma ...

Thickness planing is the sizing of the material to a desired thickness, while creating a smooth surface parallel to the opposite side of the board. The art of thickness planing consists mainly of using good judgement about the depth of cut in various situations. You must take into account: 1 ...