Gravely PROMASTER 890015* Owner's/operator's Manual

Model 890015* 08493200A 12/03 Supercedes 08493200 Printed in USA Promaster 310 Grass Catcher *NOTE: Installation requires a separate mower boot kit, p/n 04916000 for 60" decks, p/n 04916100 for 50" decks. ...

Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Storage. . . . . . . . . . . . . . . . . . . . ...

SAFETY ALERTS Look for these symbols to point out important safety precautions. They mean: Attention! Personal Safety Is Involved! Become Alert! Obey The Message! The safety alert symbols above and signal words below are used on decals and in this manual. Read and understand all safety messages. NOTATIONS NOTE: General reference information for proper ...

Warning - Engine ASSEMBLY SAFETY RULES Read, understand, and follow all safety practices in Owner/Operator Manual before beginning assembly. Failure to follow instructions could result in personal injury and/or damage to unit. ALWAYS remove key and wire from spark plugs on unit before assembly. Unintentional engine start up can cause death or serious ...

DO NOT try to stabilize the machine by putting your foot on the ground. Know the weight of loads. Limit loads to those you can safely control and the unit can safely handle. ALWAYS keep protective structures, guards and panels in good repair, in place and securely fastened. DO NOT operate in reverse unless absolutely necessary. ALWAYS look down and be ...

Unpacking Unit IMPORTANT: Remove contents from carton carefully. Place cover assembly on a flat piece of cardboard to avoid scratching it. Tools Required • Wrenches: 1/2", 9/16", 3/4", 15/16" • Drill: 11/16" ASSEMBLY Refer to Parts section for illustrations and parts locations. NOTE: Installation requires a separate mower boot kit, p/n 04916000 f ...

REMOVING BAGGER 1. Disconnect hose from blower inlet and mower boot. 2. Remove klik pins from catcher weldment and remove catcher from unit. 3. Remove mower boot from deck. 4. Replace original discharge chute deflector. Throttle Lever Move lever to FAST (1) position to increase engine speed. Move lever to SLOW (2) position to decrease engine speed. N ...

UNCLOGGING GRASS CATCHER If hose or grass blower gets clogged, stop forward motion and allow unit to clear itself. If unit will not clear itself, unclog the hose/grass blower manually as instructed below. To unclog: 1. Stop unit engine and remove ignition key. Wait for all moving parts to stop. Stop grass catcher engine, wait for all moving parts to s ...

INSPECT CATCHER PARTS Before each use, inspect grass catcher parts for any holes, abrasions, or structural damage. Replace any worn or damaged parts. CLEAN UNIT Clear away grass build up in catcher before and after each use. CHECK ENGINE OIL Check engine oil before each use. See engine manual for instructions. CHANGE ENGINE OIL See engine manual for o ...