Haier AP88NACBEA Operation Manual

Safety Precautions Operation instruction Users' Attention Maintenance Trouble shooting When problems occur When troubles occur Installation instruction Installation procedure Others 1 2-3 4-5 6-10 11 12-13 14 15 16 17 18-30 31-32 CONTENTS R MODE FAN SWING TEMP C ...

In COOLING mode, the air sending is set at AUTO, when the indoor temperature is near the set temperature, the fan speed will lower automatically.In HEATING mode, when room temperature reaches the set temperature, the compressor will stop running, and the fan will change to LOW FAN or stop.In DEHUMIDIFYING mode, the fan speed will change a ...

The interface of the refrigerant pipe 2 Note: Open the power switch 12 hours before the unit running.Do not cut off the power when short time stop the unit (like one day and one night ),this is to protect the compressor. Do not block the a ...

Wire Controller 14.Network control display Used to adjust the time of timer and clock When the wire controller appears abnormal condition, use a sharp-pointed article to press this button to make the wire controller resume normal After cleaning the air inlet, press this button, the unit can start to operate 12.Humidifying state display Used to ...

to guarantee the normal operation of the system. The following lists two kinds of safety precautions ì Warningî and ì Noticeî . For the items that the improper use may cause death or serious injury are listed in ì Warningî volume. Howeve ...

used for any other purposes than intended such as for preservation of food, flora and fauna, precision devices or work of art. Do not put the fire devices in the places, which the air from the air conditioner can directly blow. It may cause deterioration of the articles. It may cause the fire devices canno ...

Operation instruction MODE FAN SWING TEMP CLOCK TIMER SET SLEEP FILTER RESET RESET ON/OFF HEAT Fan operation About FAN operation: FAN operation refers the air conditioner does not perform COOLING and HEATING operation, but FAN operation. In this mode, the air conditioner cannot perform AUOT FAN operation, and does show the ...

AUTO LOW FAN MED FAN HIGH FAN AUTO MODE FAN SWING TEMP CLOCK TIMER SET SLEEP HEAT FILTER RESET SET RESET ON/OFF Hints: The wire controller can memorize the working condition of each time. When start the unit for the second time, just need to press ON/OFF button, the air conditioner will ...

SET RESET ON/OFF Operation instruction Sleep operation Use of SLEEP function After turning on the unit, setting the working mode, then press SLEEP button to make the air conditioner have the previous Sleep time (powered on for the first time or after performing Sleep is 1h). The Slee ...

Operation instruction OFF ON OFF ON AM PM AM PM TIMER ON TIMER OFF TIMER ON-OFF Blank MODE FAN SWING TEMP CLOCK TIMER SET SLEEP HEAT FILTER RESET ROOM RESET ON/OFF Before using TIMER function, calibrate the clock first (referring to page 4). When you wake up in the morning, before going back to home after work or after going to ...