Haier XQB70-10 Operation & User’s Manual

Safety precautions .......................1 Introduction of the special functions.........3 Installation and adjustment ..................3 Install the water inlet hose............5 Preparation before washing .............7 Put in the laundries .........................8 Put in the detergent ...................... ...

Honourable users, Thank you for choosing our products. Our products integrate high-tech, precision,frontier science.To facilitate using it, please read this manual carefully and operate this machine according to it. Before Using Before Using Names of the parts the end connecting to the water inlet hose jointer t ...

ptacle with rated voltage.If the power cord is three-phase wire,please use three-phase rec- eptacle.The earthing terminal of the receptacle must be earthed reliably.If it is two-phase wire, please guarantee that the earthing wire is ear- thed reliably.If possible ,pl ...

machine by yourself. Do not put any hot or heavy items (such as the kettle with hot water ) on the washing machine. Do not wash laundries with volatile materials (such as thinner, petrol etc.) The handicapped or children without care shall not use the machine. Keep the machine away from direct sunlight and ...

shank base of the machine is 2 . The slanting or rough ground will result in unstable running or stoppage of the machine. Please adjust it with following methods: Adjust the adjustable foot: Install the bottom plate After you open the package, please lean the washing machine gently down on soft items ( like the towel cloth, b ...

less than 10cm, or the drainage will not be smooth, and cost such long time that the machine may stop at mid way. 2.Do not trample or press the drain hose. If the drain hose is too long, cut it at mid point. To make smooth drainage, cut the front end of the hose slantingly. 4.If extra drain hose is nee ...

It is required that the front end shall be longer than 10mm. The outlet end surface of the tap shall be flat and smooth. If not please file it to avoid leakage. 2.Loosen the screw till the water tap can be accessed. Put the jointer of the water inlet hose on the tap. See to Figure 2. (If the tap diameter is too la ...

cushion. Please check if the cushion is dropped or damaged before each usage. If it happens please contact our after-sale department immediately. 2.Put the nut of the water inlet hose on the valve jointer. 3.Fasten the nut. Swaying it gently to confirm if it's suitable. 1.Close the water tap. 2.Press ...

Take out the coins , sand, hairpins etc. Fasten the buttons and zippers. When the pulsator is running , the buttons of the laundries may cause noise. For t h e s a k e o f discretion,please put the laundries with buttons into other laundries. Preparation before was ...

working suit up,down jeans about 800g The capacity of washing and spinning of the machine refer to the largest weight of the standard laundries under dry condition that can be washed or spinned in one time. One time washing quantity shall be lower than the rated capacity. The largest capacity of this machine is 7.0kg. T ...