Intermec EasyCoder PD41 Instructions Manual

Intermec Technologies Corporation Worldwide Headquarters 6001 36th Ave.W. Everett, WA 98203 U.S.A. www.intermec.com The information contained herein is provided solely for the purpose of allowing customers to operate and service Intermec-manufactured equipment and is not to be released, reproduced, or used for any ot ...

iii Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 Printer Firmware Requirements. . . . . . . . . . . . . . . . . . . . . . .5 Setting Network Parameters from the Printer Home Page. . .6 Setting Network Parameters with PrintSet 4 . . . . . . . . . . . . .7 Setting Networ ...

5 Introduction These instructions describe the various ways you can access and set the network parameters on a PD41 printer equipped with an EasyLAN Ethernet network card. The instructions apply equally to a PD42 printer, but are less relevant since network parameters can be changed directly from the printer display. On ...

Setting Network Parameters from the Printer Home Page You can change all network parameters by using your web browser to access the printer home page. To access the home page, you need the IP address of the printer. As a default setting, the printer is set to automatically receive an IP address from the network, but c ...

7 Setting Network Parameters with PrintSet 4 PrintSet 4 is a PC-based software application that lets you configure your Intermec printer from your computer. The program is available on the PrinterCompanion CD, and can also be downloaded from the Intermec web site. PrintSet 4 requires that your PC is running Microsoft Wi ...

Setting Network Parameters With Fingerprint and IPL Commands These instructions require that you start by establishing a serial connection between your printer and your PC. To establish a serial connection 1 Use an RS-232 serial cable to connect the printer to your PC. 2 (Optional) Put the printer in Dump mode. Dump m ...

9 Setting Network Parameters with Fingerprint Commands If your printer is running Fingerprint firmware, you can modify all network parameters with the Fingerprint Setup command. To modify network parameters with Fingerprint commands 1 Establish a serial connection between your computer and printer, as described on page ...

n192.168.235.86, 255.255.255.0, 192.168.236.1 Once you have set the parameters above you can use your web browser to access the printer home page and make the rest of your changes there. Setting IP Address Using ARP’n’PING Use the ARP’n’PING method to set the printer IP address if your network d ...