Philips D700 Short User Manual

Warning • The Electrical network is classified as hazardous. The only way to power down the charger is to unplug the power supply from the electrical outlet. Ensure that the electrical outlet is always easily accessible. • Refer to safety information before using the product. • This product complies with European R&TTE dir ...

Adjust the volume End calls Turn the speaker on/off Mute/unmute the microphone Enter a pause Standby Access the main menu Phonebook Call log Make and receive calls Make intercom call Lock/unlock the keypa ...

Insert batteries Charge your phone Charge 8 hours Configure your phone 1 When using your phone for the first time, you see a welcome message (country dependent). 2 Set the country and language if prompted. 3 Set the date and time. • If the time is in 12-hour format, press to select [am] or [pm] (country dependent). > 84% 68% - 84% 52% - 6 ...

2 Follow on-screen instructions. Call from the phonebook 1 Press . 2 Select a record and press . Direct access memory You have 9 direct access memories (Keys 1 to 9). To dial the saved phone number automatically, press and hold on the keys in standby mode. Depending on your country, keys 1 and 2 are prese ...

Silent mode Sets time during which the phone will not ring > [Silent mode] MySound Customizes the sound of voices to your liking > [MySound] Eco mode Reduces power consumption / transmission power; reduces radiation and range by approximately 60% > [Eco mode] Eco+ mode Eliminates radiation in standby mode (causes 2 seconds ring delay, 50% sho ...

550 mAh batteries Use only the supplied batteries. Adapter Base and charger: Philips: MN-A102-U130 S003IB0600040 Input 100-240 V~ 50/60 Hz 200 mA 100-240 V~ 50/60 Hz 150 mA Output 6 V 400 mA 6 V 400 mA Phonebook with 250 entries Call log with 50 entries Talk time: 20 hours Stand ...

No signal bar is displayed on the screen. • The handset is out of range. Move it closer to the base station. • If the handset displays [Register your Handset], put the handset on the base until the signal bar appears. If I fail to pair (register) the additional handsets to the base station, what do I do? Your base memory is ful ...