Vivotek FD7130 Quick Installation Manual

This guide describes the basic functions of FD7130 All detailed information is described in the user's manual. FD7130 IP Surveillance Vandal-proof . Tamper Detection . PoE English ᖅϛ Рҏᇭ Español Português ᙏϛ Français Deutsch Italiano Türkçe Polski Русский Česky Svenska ...

E li h Power off the Network Camera as soon as smoke or unusual odors are detected. Contact your distributor in the event of occurrence. Keep the Network Camera away from water. If the Network Camera becomes wet, power off immediately. Do not place the Network Camera around heat sources, such as a television or oven. Refer to your user’s manual for ...

Do not place the Network Camera on unsteady surfaces. Do not touch the Network Camera during a lightning storm. Do not disassemble the Network Camera. Do not drop the Network Camera. Do not insert sharp or tiny objects into the Network Camera. ...

E li h Software CD FD7130 with an RJ45 or M12 Cable Quick Installation Guide / Warranty Card Screwdriver Alignment Sticker Ground Wire / Screws Liquid Tight Connectors for RJ45 or M12 Cable Package Contents 1 RJ45 M12 RJ45 Silica Gel ...

Network Camera Model No: FD7130 Made in Taiwan This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Pat. 6,930,709 MAC:0002D107258A ...

E li h 1 2 3 4 5 6 7 8 (D) (B) (C) (A) (E) Cabling Assembly 3 Components of the Waterproof Connector Screw Nut (C) Housing (D) Gasket (E) Seal (B) Sealing Nut (A) RJ45 Cable Dimension (unit: mm) Prepare an Ethernet cable and strip part of the sheath. Insert the housing into the screw nut. Insert the seal into the housing. Insert the stripped Ethernet ...

1 2 3 4 5 6 7 Ø4.5mm~Ø6.5mm (C) (D) (B) (A) (E) M12 Cable Connector Components of the Waterproof Connector M12 Cable Dimension (unit: mm) Assembling Steps Clamp Ring (C) Gasket (D) Plastic Nut (E) Seal (B) Sealing Nut (A) Prepare an Ethernet cable and strip part of the sheath. Insert the seal into the clamp ring. Insert the gasket into the clamp rin ...

E li h First, use the supplied screwdriver to detach the dome cover from the camera base. Insert your MicroSD/SDHC Card if necessary. Then, follow the steps below to install the camera to either the ceiling or the wall: 1. Attach the supplied alignment sticker to the ceiling/wall. 2. Using the 3 screw circles on the sticker, drill 3 pilot holes into t ...

1 2 B A 3 4 Wall Mount Installing the Ground Wire As shown in the following figure, please secure one side of the supplied ground wire to the screw hole, then route the other side of the ground wire to the ground. Please secure the screws tightly to avoid moisture. ...

E li h Network Deployment 5 Power over Ethernet (PoE) POWER COLLISION LINK RECEIVE PARTITION 1 2 3 4 5 PoE Switch When using a non-PoE switch Use a PoE power injector (optional) to connect between the Network Camera and a non-PoE switch. When using a PoE-enabled switch This Network Camera is PoE-compliant, allowing transmission of power and data via a ...