Intermec EasyCoder F2 Installation Manual

on the part of Intermec Printer AB. © Copyright Intermec Printer AB, 2002. All rights reserved. Published in Sweden. EasyCoder and Fingerprint are registered trademarks of Intermec Technologies Corp. The word Intermec, and the Intermec logo are trademark ...

Chapter 1 Description Introduction RFID Tag RFE SYSTEMS www.idsys.co.uk SYSTEMS www.idsys.co.uk Antenna Information Reader with Transceiver System & Application Hardware & Software Write to Tag Read from Tag The term RFID (radio frequency identifi cation) describ ...

2 Chapter 1 Description The RFID 13.56 MHz Interface Board is an optional device for EasyCoder F2 or EasyCoder F4, that provides these printers with two extra interfaces, "uart2:" and "uart3:". The printer must be fi tted with the Intermec Fingerprint v7.xx fi ...

Chapter 1 Description RFID Media Recom- mendations Because the RFID tag is a part of a system consisting of the printer, the tag, the media in which the tag is fi tted, and the reader, all applications should be tested before installation. As regards the prin ...

4 Chapter 1 Description DECLARATION OF CONFORMITY We, Intermec Printer AB Idrottsvägen 10 Box 123 S-431 22 Mölndal Sweden declare under our sole responsibility1, that the product EasyCoder F2/F4 RFID 13.56 MHz to which this declaration relates is in conformity ...

Chapter 2 Fitting the Interface Board #T20 Torx screws (3 places) Field Installation Generally, the illustrations show an EasyCoder F4 printer. However, the same principles applies to EasyCoder F2 printers. The RFID 13.56 MHz Interface Kit comes in two versions, o ...

6 Chapter 2 Field Installation #T10 Torx screw Cover Plate #T10 Torx screw • Remove the two #T10 Torx screws that hold the interface cover plate on the printer’s rear plate. Remove the cover plate. • Save the cover plate for possible later use. Keep the s ...

Chapter 2 Field Installation Fitting the Interface Board, cont. P35 IC305 P32 IC304 P33 P81 1-971615-00.P01 C7 R12 R15 R14 R13 R9 R8 R3 R2 R1 JP1 IC7 IC6 IC5 IC2 IC1 C15 C14 C13 C12 C11 C6 RP1 C5 C4 C3 C2 P5 P6 C1 C10 C16 D1 F1 F2 F3 F4 F5 F6 F7 F8 F9 F10 F11 ...

8 Chapter 2 Field Installation The shape of the antenna differs between EasyCoder F2 and EasyCoder F4. The antenna is fi tted inside the lower media guide. To be able to fi t it, you must remove the tear bar, the guide link, and media guide assy. • Raise the ...