Intermec EasyCoder E4 Installation And Operation Manual

Installation & Operation P/N 1-960418-05 Edition 2 November 2000 ...

1 Preface 1. Introduction Introduction..........................................................................................5 Safety Requirements..................................................... ...

2 Preface Contents, cont. Appendix 1 Technical Data.................................................................................. 44 Appendix 2 Media Specifi cations.............................................. ...

3 Preface FCC Notice (United States of America) WARNING This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instructions manual, may cause interference to radio communications. It has been tested and found to comply with the limits ...

4 Preface Declaration of Conformity We, Intermec Printer AB Idrottsvägen 10 Box 123 S-431 22 Mölndal Sweden declare under our sole responsibility1 that the product EasyCoder E4 to which this declaration relates is in conformity with the following standards Electrical Safety: EN 60950 EMC Emissions: ...

5 5 Chapter 1 Introduction The EasyCoder E4 printer is a combined thermal transfer and direct thermal printer. It is simple to operate, and is designed to work with any computing device capable of ASCII output. The EasyCoder E4 can print labels, tickets, or tags in three ways: • Tear-off (Straight- ...

6 Chapter 1 Introduction Safety Requirements Product Labeling Intermec assumes no responsibility regarding the CE Directive if the printer is handled, modifi ed, or installed in any way other than that described in Intermec’s manuals. Caution • Read this manual carefully before connecting t ...

7 7 Chapter 2 Before you install the printer, examine the package for possible damage or missing parts: • Open the box and lift the printer out. • Check that the printer has not been visibly damaged during transportation. Keep the packing materials in case you need to move or reship the printe ...

8 Chapter 2 Installation Main Parts Transfer Ribbon Rewind Hub Transfer Ribbon Supply Hub Media Supply Roll Post Thermal Printhead Tear Bar Printhead Lift Lever Label Taken Sensor Guide Shafts Liner Takeup Hub The left side of the case is not designed to be opened by the operator. Front Cover Rele ...

9 Chapter 2 Installation Connections PCMCIA card slot RS-232 serial interface connector AC receptacle ON/OFF switch 1 Place the printer on a level surface, near an AC outlet. You should be able to easily access the printer to load media, to load ribbon, and to remove the printout. 2 Check that ...