Intermec EasyCoder PF4ci Installation Instructions Manual

Corporate Headquarters 6001 36th Ave. W. Everett, WA 98203 U.S.A. www.intermec.com The information contained herein is proprietary and is provided solely for the purpose of allowing customers to operate and/or service Intermec manufactured equipment and is not to be released, reproduced, or used for any other purpose without ...

Printer Firmware ........................................................................... iv Installation Kit .............................................................................. iv 1 Description General Information ................ ...

Introduction This Installation Instructions booklet describes how to install a cutter in an EasyCoder PF4i or PF4i Compact Industrial printer. The installation instructions also describes how to control the cutter in Intermec Fingerprint and in Intermec Programming Language (IPL). This k ...

1 This chapter describes the cutter and provides essen- tial technical data. ...

Chapter 1 — Description General Information The cutter is a factory-installed or field-installable option for the EasyCoder PF4i and PF4i Compact Industrial printers. The cutter auto- matically cuts off the media after printing according to instructions in the controlling firmware. The cut o ...

3 Chapter 1 — Description Media The cutter is primarily intended to cut paper-based media in the form of continuous stock. It is also possible to cut through the liner between labels, but be careful not to cut through the labels themselves, because the adhesive will stick to the cutting blade and ...

Chapter 1 — Description Measures and Weight When a cutter is installed, the measures of the printer are: The weight is increased by 1.16 kg (2.56 pounds) 253 mm (9.96 in) 132 mm (5.20 in) 447.0 mm (17.60 in) ...

5 2 Physical Installation This chapter describes how to physically install the cutter in an EasyCoder PF4i or PF4i Compact Indus- trial printer. The electronics compartment contains high voltage components (380V). Always disconnect the power cord before opening the electronics compartment! ...

Chapter 2 — Physical Installation Installation Instructions • Switch off the power and disconnect the power cord and possible communication cables. • Remove the front/left side moulding that covers the electronics compartment. The moulding is held by three #T20 Torx screws as illustrated b ...