Decware SE84ZS Owner's Manual

STEREO POWER AMPLIFIER SE84ZS OWNERS MANUAL ...

an equilateral triangle, is intended to alert the user to the presence of unin- stalled “dangerous voltage” within the product’s enclosure that may be of risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating an ...

fier you have illustrated a desire to rise past the normal hi-end hype and own a truly ex- ceptional piece. It is a product based on the old school way of doing things when it was fashionable to push quality to an art form. Your amplifier was hand-built by the very best artisans who have perfected the c ...

Important Information 1 Caution: To prevent electrical shock make sure that the AC POWER CORD IS NOT CONNECTED TO THE SE84ZS when inserting or removing Vacuum Tubes, as there are haz- ardous voltages present at the pins of the Tube Sockets. 2 When Vacuum Tubes are installed or removed make sure to seat them properly in ...

The SE84ZS is designed to use either EL84 output tubes or SV83 output tubes. No adjust- ments are needed when switching from one to the other. Of the type SV83 tubes carrying the Svetlana name there is one batch known to be questionable and ARE NOT RECOMMENDED for use in this amplifier. The tube on the left is an acceptable SV83 outpu ...

The SE84ZS is designed to use your choice of three different input (or signal) tubes. 6N1P (a Russian tube from the same factory that makes the SV83 and 6P15P-EV) 6DJ8 (a popular low noise tube both available in current production by numerous manufacturers and in N.O.S.) 6922 (a popular variant of the 6DJ8 also avail- able by a wide ...

the world! Unlike the stereotypes associated with single ended triode designs, the SE84ZS has many unique features that set it apart from the rest. It’s point-to-point construction, lack of circuit boards, and signal path consisting of only a single capacitor and two resistors means noth- ing s ...

14.75 inches deep with a height of 6.5 inches. PLACEMENT With the jacks vertically mounted at the rear of the amplifier, it is possible to push the amp all the way to the rear of a shelf. How- ever, we recommend keeping a 2 inch spacing on all sides and at least 6 to 10 inches of space above the ampli ...

To run the amplifier in Stereo, simply connect the left and right input jacks to your source or preamp and the left and right output binding posts to your speakers. If using the variable inputs, the volume control located at the front of the amplifier will control the output level of both channels at the same time. To bridge th ...

• Dimensions 8.5" H x 7.250" W x 14.0" D • Circuit type Single ended Class A Triode • Power output 2.3 watts RMS into 4 ohms • 5 watts RMS into 8 ohms when bridged • NOTE: Power increases as ohms decrease • Stable into 1 ohm speaker loads • Input voltage 2.0 volts for full output • Noise / Hum Less th ...