Master Bilt MSC30 Installation & Operation Manual

Master-Bilt Products 908 Highway 15 North New Albany, MS 38652 Phone: (800) 684-8988 REV: LN-12-21-11 ...

INTRODUCTION�������������������������������������..3 STORE CONDITIONS...������������������������������..����3 SAFETY INSTRUCTIONS�����.����������������.�� ...

installing, using and servicing a MSC/MSF case. A parts list is included in with this manual. Read all these documents carefully before installing or servicing your equipment. STORE CONDITIONS The MSC/MSF case are designed to operate in the contro ...

compressor oil colling system. - Do not expose the equipment to heat sources such as stoves, ovens, green houses, hot walls and solar radiantion. - The equipment must be installed in a space with good air circulation and vetiltion to maintain the per ...

1. BASKETS 2. THERMOSTAT 3. AIR VENTS 4. CASTERS W/BRAKES 5. SLIDING BLASS LIDS 6. CASTER 7. CABINET Curved Freezer Flat Freezer ...

dealer abou any damage immediatel after delivery. - The freezer must be installed in a dry room that is at a normal temperature and has adequate vetilation. Place the freezer so it will not at any time obstruct the circulation of air around it (allow at ...

with directive Standard 82/499/CEE. The freezer should be plugged into an outlet that has the correct voltage and frequency. These data are specified on the lable located on the back of the freezer. The standard voltage in the US is 115V/60Hz al ...

Adjusting the Thermostat - Turn the piece on the bottom of the protector vent to the left. Push up the latches located under the vent. - Pull the bottom rack out and then down to remove. The thermostat is on the top left in the cmpressor compartment. To lower the temperat ...

food. - This means putting only already frozen products into the freezer. - Remember that you must load the freezer up to the load line or, if the load line is not visible, up to 4 inches below the bottom glass lid. This is to ensure a product temper ...

• Put the items stored in the freezer in a cool place or wrap with an insulating material. • The freezer must be unplugged from the outlet. • Keep the lids open or remove lids and place them on the floor with care. • Clean the freezer with warm water and mild det ...