Oki GL408e Install Manual

The front cover can now be removed. Remove the lock shaft located at the front of printer. (Do not lose this part as it is essential for the installation of dispenser option) Note This lock shaft must be removed for the successful installation of the internal rewinder. Remove a total of 9 screws (cross recesse ...

The fifth screw to be removed is shown here. The sixth and seventh screws are shown here, securing the base to the front of the chassis. The last two screws are on the electronic section as circled here in orange. Figure 1e. Removing the fifth of nine screws Figure 1f. Removing the sixth and seventh screws Fig ...

Oki GL408e A total of seven screws (cross recessed hexagonal bolt M4x10) are used to install the internal rewinder-dispenser to the printer chassis (Do not damage the PCB when using any tool such as screwdriver) Do not tighten all seven screws until you are sure the installation alignment is correct. Also c ...

Turn the printer ON and take it OFFLINE (by pressing the LINE button). Go into the printer’s ADVANCED Mode and scroll to the Media Handling menu. Select Peel-Off to activate the peel-off and rewinder functions, and then exit the menu. Perform some printing to test the proper functio ...

Oki GL408e Make sure the printer is OFF and disconnected from the power supply and all other cables. Remove the side cover using a #2 phillips screwdriver to remove three screws as circled in orange. Keep these screws aside for later use when putting back the side cover. Slide the side cover outwards by sliding it horizontally by a ...

Oki GL408e This instruction manual uses various warning icons to help you understand the safe operation of your printer. Explanations of the icons are below. WARNING! Indicates neglectful or erroneous use may cause irreparable damage to the product, serious injury to the operator, or worse. CAUTION! Indicates a specific point where caution ...

Oki GL408e For printer models: GL 4xxe Series Read this Installation Guide before and during the installation of the above accessory. Keep this Installation Guide handy for future reference. ...

Oki GL408e Finally, carefully separate the base plate of the printer from the main chassis. This can be done by placing the printer on its side and pulling the base plate out. Figure 1h. Separating the base from the printer ...

Oki GL408e If the front cover snaps into place correctly, you can proceed to further tighten the screws permanently, followed by inserting the thumbscrew used to secure the printer’s front cover in the first step of this guide. Finally, connect the printer power cable as shown, routing it through the slot at t ...

Oki GL408e This quick guide provides important information on how to setup your new SATO product. Be sure to read this quick guide thoroughly before using this printer. It is an integral part of the product and should be kept in the immediate vicinity of the device and available to the operating staff. 1.2 Limitation of liability ...

Oki GL408e To facilitate easier mounting, it is recommended that you remove the front cover of the internal rewinder-dispenser beforehand. Pull down the side cover of the internal rewinder and remove two bind screws (M4x4) located as shown within the orange circles. Remove ...