Polycom MGC-100 Installation & Configuration Manual

General Safety Precautions Follow these rules to ensure general safety: • Keep the area around the Polycom MGC+ unit clean, free of clutter and well ventilated. • When lifting the MGC+50/100, two people at either end should lift slowly with their feet spread out to distribute the weight. Always keep your back ...

1 Place the MGC+ unit on a stable flat surface in the selected location. 2 Release the clasp locks at the bottom, and lift the MGC+ package top cover. 3 Lift the MGC+ unit and place it on the required flat surface. If you are rack mounting the MGC+ unit, allow a minimum clearance of 3” above the unit. 4 To mount the ...

The system is shipped with a default IP address: 129.254.4.8. When the MGC+ is installed for the first time, you must change the default IP address of the MCU. 1 Insert the Compact Flask disk into the Compact Flash adaptor (supplied with the MGC+ accessory kit). 2 Using a text editor application, open the LAN.CFG fi ...

1 To connect the MGC+ unit to your site’s network, connect network cable to the LAN connector on the rear I/O panel of the MGC+ Control Module and to the network. 2 To connect an IP card to the IP network, connect the 8-pin RJ-45 connector of the LAN network cable to the LAN RJ-45 jack on the IP IO panel of each IP card on ...