Printek Mt2 Operator's Manual

Part Number Description 91310 Paper 35-Pack 91304 Battery (Li-Ion, 2200mAH) 91308 Battery (Li-Ion, 2200mAH) – 5-Pack 91309 Battery (Li-Ion, 2200mAH) – 20-Pack 91393 Print Head Cleaning Pen (Box of 12) 91394 MCR Cleaning Card (Box of 50) 91247 120VAC Power Adapter 91334 240VAC Power Adapter 91260 12VDC Power ...

The following table describes the information provided by the printer’s status indicators that are located on the top of the printer. Indicators on Front of Printer Indicator State Status Green Printer is on and ready to receive data. This indicator is also on if the printer is in a low power state and waiting to rec ...

Printek Mt2 • Be sure to fully recharge the battery before long or battery intensive printing sessions. Certain operations such as printing receipts with a lot of bar codes and graphics may drain the battery more quickly than others. Note: F ...

Printek Mt2 The Magnetic Card Reader is a factory-installed option. This option requires special application software to read and process cards with a magnetic stripe, such as credit cards or a driver’s license. Refer to the following figure if your printer is equipped with the optional magnetic stripe reader an ...

Printek Mt2 environments including field service, field sales, restaurants, ticketing and many other applications where point of service receipts are required. Each printer includes: • An Mt2 or Mt2B Printer • One Battery • One Roll of Paper • A ...

Printek Mt2 Command String Printer Action ESC k 5 Selects 24 CPI Normal Font (8x12) ESC k 4 Selects 21 CPI Normal Font (9x21) ESC k 3 Selects 19 CPI Normal Font (10x21) ESC k 2 Selects 16 CPI Normal Font (12x21) ESC k 1 Selects 12 CPI Normal Font (16x21) ESC k 0 Selects 13 CPI Rotated Font (14x16) Pr ...

Printek Mt2 120VAC, 240VAC, 12VDC and 24VDC power sources. Follow the steps listed below to charge the battery. An optional external two-bay charger is also available. • Plug the power adapter into a pow ...

operation. Do not operate in an enclosure unless properly ventilated. Make sure no ventilation openings are blocked or obstructed, which may result in the printer overheating. Do not operate near a heat source. No user-serviceable parts inside. Refer service or repairs to a qualified service ...

Attaching The Belt Loop System The belt loop system consists of two parts: • A knob located on the back part of the printer just above the battery door • A belt loop strap with a click on connector After sliding your belt through the strap of the belt loop: • Insert the knob located on the bottom of the printer in ...

• Press and hold the PAPER FEED button. • While continuing to hold the PAPER FEED button, press the ON/OFF button to turn the printer on. • The printer will start printing the self-test messages. You may now release both buttons. • The Self-Test will stop after all the printer information is print ...

The following tables show the symbols for character values 32 through 255 (decimal). These character sets are selected using the ESC – F – n command International Character Set PC Line Draw Character Set 17 ...