RF Technology Eclipse2 Technical Manual

List of Associated Publications Document Number Description TPR-0308920019 IP Commander User Manual Disclaimer Due to our policy of continuous improvement of our products and servic ...

Contents CONTENTS ........................................................................................................... 3 INTRODUCTION ........................................ ...

Channel Programming .................................................................................................................... 16 Channel Selection ....................... ...

Although there are no dangerous mains voltages present within the equipment, the following general safety precautions as would normally apply, should be observed during all phases o ...

Introduction The Eclipse2 series is a Base Station designed for Conventional Analogue FM and Conventional APCO P25 modes of operation. Internally, it is driven by software, allowing ...

Noise squelch: Adjustable from 0 to 26 dB SINAD Carrier squelch: Adjustable from –120dbm to –60dBm Audio Response: 300Hz to 3000Hz +1/-3dB, Flat or 6dB per Octave de-emphasis Au ...

Operation The Reciter will need approximately 30 seconds to boot up after power up. When the transceiver is ready to operate, a voice report (if enabled) can be heard from the front ...

Pin No. Description Specification 1, 14 Power supply, positive Input: +13.8VDC (minimum 10.8V, maximum 16V) 13,25 Power supply, negative Input: Ground 2 System serial bus, Data out ...

Ethernet: The RJ45 Ethernet connector is used for networking the base station via IP protocol, a PC can use this connector to monitor and control the base station locally or remote ...