Lamona LAM8605 Installation Instructions Manual

Warning for hazardous situations with regard to life and property. Warning for electric shock. Throughout this manual the following symbols are used. ...

Risk of damage to appliance: Do not attempt to move the appliance by the door. Dishwasher must be fixed securely and level. Risk of damage to property: Take care of surrounding area when moving the appliance to prevent damage to flooring, wall coverings, pipes etc.. NOTE: If the electricity cable is damaged it must be replaced by a compete ...

cross head screw drivers DO NOT use high speed impact power tools. Sealant www.howdens.com Installation Copyright © 2016 Howden Joinery Ltd. All rights reserved. Parts supplied Tools required ...

818mm (+100) *HJ Kitchen Installation Manual (*nominal 890mm) min 570mm min 600mm min 15mm 100mm 44mm 160mm 818mm (+100) 100mm (+100) 550mm 598mm 820-920mm min 570mm min 600mm Plus foot addition +50mm Foot, max 50mm www.howdens.com 1 - Dimensions 2 - Opening height Opening height from the floor ...

impact power tools. DO NOT damage the plastic screw heads. _ + Flat head screw driver + _ Final height adjustment may be required after positioning of the dishwasher. = = TOP Centre line 267mm www.howdens.com 3 - Height adjustment Front feet Rear feet 4a - Décor door - ‘H’ frame set-up ...

Cross head A (3.5x14) x2 www.howdens.com 4b - Décor door Unscrew the two screws and remove the plastic ‘H’ bracket. Retain the screws for stage 4c. 4c - Décor door Fit handles at this stage, if required, (screws may need countersinking). Secure with the screws retained from stage 4b plus two additional screws from the accessory bag. ...

2mm www.howdens.com 4d - Décor door Remove the existing fixings and using the 43mm screws supplied, secure at positions 2 and 5. Ensure correct alignment with the top of the door, (2mm overlap at top). DO NOT use hole 1, especially when fitting an integrated handle décor door. DO NOT fully tighten the screws at this stage. 1 2 3 4 5 1 2 3 ...

Cross head A (3.5x14) x2 60mm 130mm 130mm = 267mm 2 x 356mm drawer fronts = 712mm Normal door height = 716mm Therefore space between drawer fronts = 3-4mm TOP Centre = www.howdens.com 5a - Décor drawers frontal - ‘H’ frame set-up 5b - Décor drawers frontal Unscrew the two screws and remove the plastic ‘H’ bracket. Retain the scr ...

2mm www.howdens.com 5c - Décor drawers frontal Remove centre rail. 5d - Décor drawers frontal Remove the existing fixings and using the 43mm screws supplied, secure at positions 2, 3 and 5. Ensure correct alignment with the top of the door, (2mm overlap at top). DO NOT use hole 1, especially when fitting an integrated handle décor door ...

If necessary make final alignment and fully tighten the screws. 6 - Worktop protection strip Ensure a clean and dust free surface. NOTE: This strip must be fitted to avoid damage to the worktop. Ensure tape is set to edge of square edged worktops. Make sure screws are fastened flush but do not over- tighten. ...