Record Power TS250RS Instruction Manual

Save this manual for future reference. ...

1.1 FOREWORD 1.2 MACHINE IDENTIFICATION 1.3 CUSTOMER SERVICE RECOMMENDATIONS 2 SAFETY PRECAUTIONS 2.1 SAFETY REGULATIONS 2.2 RESIDUAL RISKS 2.3 SAFETY AND INFORMATION SIGNALS 3 SPECIFICATIONS 3.1 MAIN COMPONENTS 3.2 TECHNICAL SPECIFICATION 3.3 ELECTRICAL CONNECTION 3.4 NOISE L ...

1.1 FOREWORD Some information and illustrations in this manual may difer from the machine in your possession, since all the configurations inherent in the machine complete with all the optionals are described and illustrated. Therefore, refer only to that information strictly connected with the machine configuration you have purchased. ...

2.1 SAFETY REGULATIONS Read carefully the operation and maintenance manual before starting, using, servicing and carrying out any other operation on the machine. The manufacturer disclaims all responsibilities for damages to persons or things, which might be caused by any ...

may still be present, among which the most recurring are: - contact with tool - contact with moving parts (belts, pulleys, etc..) - recoil of the piece or part of it - accidents due to wood splinters or fragments - tool ...

2 - Main table 3 - Blade guard assembly 4 - Blade 5 - Rear extension table 6 - Sliding table 7 - Telescopic fence 8 - Square sliding table 9 - Upper cabinet assembly 10 - Switch 11 - Lower cabinet assembly 12 - Plate pusher 13 - ...

- Electrical installation should be carried out by competent, qualified personnel. - The mains connection should be made using the terminal box. - Replacement of the power supply cable should only be done by a qualified electrician. To avoid electrocution or fire, any maintenance or repair to electrical system should be done only by ...

The machine is equipped with the following safety devices: (Fig.3.6) A - Stop button. When the button is pressed, the power is immediately cut. B - Saw guard A B Ensure that the suction system guarantees these values at the hood-houth connection point. (Fig.3.5) Suction mouth diameter: A - Blade guard ...... ø30 mm B - Body dust suction . ...

- The machine is supplied partly assembled. Prior to use, further assembly is required. - When unpacking the machine the following components are included for the initial assembly. - If any parts are missing, do not attempt to assemble the machine; plug in the power cord, or turn the switch on until the missing parts are obtained and ...

WARNING It is prohibited to install the machine in explosive environments. The installation zone must be selected evaluating the work space required depending on the dimension of the pieces to be machined,and taking into account that a free space of at least 800 mm must be left around the machine.It is also necessary to ...