Record Power DML250 Original Instructions Manual

Mini Lathe 15001 (UK version) 15002 (EP version) Important For your safety read instructions carefully before assembling or using this product. Save this manual for future reference. Always wear safety glasses when using woodworking equipment. Always read the instructions provided before using woodworkin ...

2 General Power Tool Safety Warnings 3 Woodturning Lathe Safety Warnings 4 Record Power Guarantee 5 Specifications 6 Contents of the Package 7 Getting to Know Your Lathe 8 Assembly 9 Assembly of the Optional DML305/A Leg Stand 10 Assembly of the Optional DML305/L Extension Support and DML250 Bed Extension 11 Operation 12 M ...

Please ensure that you take the appropriate action wherever the warnings are used. 1. Explanation of Symbols i i i ii ii i Kg Mandatory Instructions Warnings Read and fully understand the instruction manual before attempting to use the machine. Indicates an instruction that requ ...

WARNING: Read all safety warnings, instructions, illustrations and specifications provided with this power tool. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term “power tool” in the warnings re ...

Safe Operation Familiarise yourself with the machine • Machining operations using wood turning lathes have a history of serious accidents. Most serious accidents resulted from the work piece being thrown from the lathe whilst turning. Other accidents can be caused by loose clothing being drawn in to the rotating work ...

“Products” means the Products sold by Record Power subject to these terms and conditions; “Record Power” is Record Power Limited, whose company registration number is 4804158 and registered office address is Centenary House, 11 Midland Way, Barlborough Links, Chesterfield, Derbyshire S43 4XA and sells through a network of ...

1. Carefully lift the lathe from the carton and check that all of the components and contents have been included. Place parts on a protected surface. 2. Clean all rust protected surfaces with white spirit. Do not use gasoline, paint thinner, mineral spirits, etc. These may damage painted surfaces. Make sure the area is well ventila ...

3 Motor positioning lever 4 Motor pulley access hatch 5 Headstock 6 Hand wheel 7 Spindle pulley access hatch 8 Spindle 9 Faceplate 10 4 prong drive centre 11 Tool rest 12 Tool rest holder 13 Tool rest holder locking lever 14 Tool rest locking lever 15 Revolving centre 16 Tailstock barrel 17 Tailstock 18 Tailstock barrel loc ...

in the OFF position until the machine is assembled. The lathe must not be lifted by only one person due to its weight. Always lift with care and hold the lathe by the bed. Installing the Tailstock Hand Wheel Handle Screw the hand wheel handle into the threaded hole on the rear of the ta ...

mm (1”) depth must be used at each end of the lathe to raise it from the bench surface and allow for movement of the motor, see Fig 8.6. If the lathe is to be mounted to a stand, unless the mounting plate of the stand allows movement of the motor, spacers must also be used. Please note: U ...