PureLink PT-E-HD10 Operation & User’s Manual

User Manual HDMI™ over Single Cat.X Extender with 2-way IR Model PT-E-HD10 Designed in Germany © 2016 PureLink GmbH All rights reserved. ...

gulations and requirements, and has been certified for international use. However, like all electronic equipments, the PT-E-HD10 should be used with care. Please read and follow the safety instructions to protect yourself from po ...

• Extend the transmission up to 50m (165ft) from the HDMI source at HD 1080i or 720p 24-bit • Extend the transmission up to 40m (130ft) from the HDMI source at Full HD 1080p 24-bit • Extend the transmission up to 20m (65ft) from the HDMI source at Full HD 1080p 36-bit • HDCP 1.1 compliant � ...

Transmitter [TX] Receiver [RX] HDMI compliance HDMI Deep Color & full 3D HDCP compliance Yes Video bandwidth Single-link 225MHz [6.75Gbps] Video support 480i / 480p / 720p / 1080i / 1080p60 HDMI over UTP Full HD: (1080p) ~40meter (130feet) (Cat.X) HD: (720p/1080i) ~50meter (165feet) (Cat ...

• 1x IR blaster • 1x IR receiver • 2x Power supply unit (+5VDC, 2A) • 1x User Manual 5. Package Contents 6. Connection Diagram 5 ...

Transmitting unit PT-E-HD10 TX Front Panel Rear Panel 1. MODE: 0 - EDID Full-HD(1080p@60) - 24bit 2D video & 7.1ch audio 1 - EDID Full-HD(1080p@60) - 24bit 2D video & 2ch audio 2 - EDID Full-HD(1080p@60) - 36bit 2D video & 7.1ch audio 3 - EDID Full-HD(1080p@60) - 36bit 2D video & 2ch audio 4 - EDID HD(1080p@30)(1080 ...

Receiving unit PT-E-HD10 RX Front Panel Rear Panel 7. HDMI OUT: Connect to a HDMI display with a HDMI male-male cable here. 8. SIGNAL LEVEL: Adjust the equalization control to the received HDMI signals. The HDMI signal level varies from MAX (strongest) to MIN (weakest) for respective transmission length from longest ...

IR Extenders IR Sockets IR Blaster IR Receiver IR BLASTER: plug in the IR blaster to emit all IR command signals received from the IR receiver from the other end to control the devices corresponding to the IR signals. IR RECEIVER: plug in the IR receiver to receive all IR command signals from the IR remote controls of ...

2. Connect a HDMI or DVI display (such as a LCD TV) to the receiving unit PT-E-HD10-RX. 3. Connect IR Blaster/Receiver to both TX and RX units. 4. Connect a Cat-5/5e/6 cable between the transmitting and receiving units. 5. Make sure thi ...

and stop turning the rotary switch whenever the audio/video is playing normally. Inappropriate signal level setting may cause overpowering issue that would shorten the product life significantly! 2. If the DVI or HDMI device re ...