PLX DM-5 Quick Start Manual

factory. Leave Jumper installed for this setup. • Step Three Terminal Jumper for first SM in iMFD daisy chain. ...

PLX DM-5 downstream from your engine block for NA and 36inch for turbo engines for optimal performance. • Step Seven Install the Wideband O2 Sensor. Install Bung (if applicable). 18mm X 1.5mm Bung ...

PLX DM-5 coming in direct contact with exhaust. This will avoid damage to O2 Sensor Harness. • Step Six Connect O2 sensor harness (female end) to SM Module input. ...

PLX DM-5 (as shown above). You will need to know the Diagram Pin Out of your specific vehicle. • Step Eight ( Not needed for stand alone setup) Connecting to ECU NB Connection WB Connection ...

PLX DM-5 use is for multiple SM Modules. Push DM-5 serial plug (figure one) firmly into TX Serial input. • Step Four Connect DM-5 male end serial (figure one) to serial TX. 1. X 2. ...

from every SM Module after the first in the iMFD in daisy chain. Leaving the first SM Module with the Jumper installed. • Step Five ( Not needed for stand alone setup) RX connects to a second SM Module to daisy chain. ...

PLX DM-5 Connect Female Clip to Analog Output Tip: Lambda wire comes disconnected from the factory. Lambda wire only needed if using alternative fuel other than gasoline. ...