Electrolux Diva Service Manual

SERVICE MANUAL DISHWASHERS  E.M.A. - Europe Spares Operations Italy Corso Lino Zanussi,30 Publication no. I - 33080 PORCIA /PN (ITALY) 599 37 44-27 Fax +39 0434 394096 Edition: 2005-12 EN “DIVA” DISHWASHERS 60 cm PNC 911 5.. … ACCESSIBILITY Production: PLV – Zarow (Poland) ...

CONTENTS: 1 ACCESSIBILITY.....................................................................................................................................4 1.1 To access the components from above, first remove the worktop (free-standing versions only):..4 1.2 To access the components housed in the base from the front of t ...

1 ACCESSIBILITY 1.1 To access the components from above, first remove the worktop (free-standing versions only): (a) Remove the two screws from the rear section. (b) Push the top forwards and release. 1.2 To access the components housed in the base from the front of the appliance (free-standing versions): (a) Remove the 5 low ...

1.4 To access components from the side, remove the relative lateral panel: (a) First remove the worktop (see 1.1), the plinth (free-standing versions) and the foot support (see 1.2). (b) Remove the three rear screws, the upper and the lower front. (c) Detach the lateral panel from the rear and slide away from the frontal anch ...

The appliance may be considered as consisting of three major assemblies: DOOR AREA - BASE AREA - TUB AREA The entire structure is enclosed by a series of removable parts such as the worktop (free-standing versions only), the door, two lateral panels, the plinth (free-standing versions only) and the foot support. Removal o ...

2.3 Tub area ‰ Tub Fitted externally to the tub: ‰ Lateral uprights ‰ Upper rear cross-member ‰ Upper front cross-member ‰ Lower front cross-member ‰ Supports for upper basket wheels ‰ External feed manifold to the upper spray arm ‰ Sump assembly ‰ Thermostat/temperature sensor + turbidity sensor ‰ Water fill tank ( ...

(a) (c) (d) (b) 3.1 Central drain filter (a) From inside the tub, use the lever to rotate the filter assembly (a+b+c) about 45° in a counter- clockwise direction, and remove the assembly from its housing. (b) Use the central ring to pull the coarse-mesh filter (a) and remove from the fine-mesh filter (b). Separate the micro ...

4 Access from above 4.1 Drying duct/fan (if featured) (a) Remove the worktop (see 1.1), for the free-standing dishwashers (b) Raise gently and detach the duct from the water fill tank, taking care not to damage the sponge sealing element between the tank and the duct. (c) From inside the tub, detach the intake ring by pressin ...

5.2.1 PCB (a) Detach the electrical connections. (b) Slide away and remove the knob-flange assembly paying attention not to damage the components. (c) Remove the 2 screws which secure it to the control panel. (d) Use a tool to release the four lateral anchor tabs. (e) Remove the board and its casing from the control pane. (b ...