Brinkmann 2411 Assembly Instructions Manual

BEFORE ASSEMBLING OR OPERATING YOUR GRILL. WE RECOMMEND TWO PEOPLE WORK TOGETHER WHEN AS SEM BLING THIS UNIT. The following tool is required to assemble this Brinkmann 4 Burner Gas Grill: • Phillips Head Screwdriver 20 PARTS LIST: 1 Grill Body Assembly 1 Left Side Table 1 Side ...

Inspect contents of the box to ensure all parts are included and undamaged. 21 1 2 9 5 11 12 8 3 4 6 10 14 7 15 17 16 13 18 ...

area and get a friend to help you put your grill together. Lay card board down to protect grill finish and assembly area. CAUTION! Some parts may contain sharp edges. Wear protective gloves if necessary. Step 1 Unfold the cart and lock into place. Step 2 Attach the tank holder to the cart by placing keyholes over bolts, sl ...

bottom of front left side cart leg. Press small back plastic foot onto bottom of back left side cart leg. Step 5 Insert the wheel assembly through the cart leg. Secure wheel assembly with cotter pin. Step 6 Insert the accessory tray into the tracks as illustrated. 23 Large Front Plastic Foot Small Back Plastic Foot ...

Lift grill body from front and rear panels to avoid injury to hands and fingers. Step 7 With the help of a friend, place grill body assembly on assembled cart frame. Rotate the bracket up as illustrated. Tighten pre-attached bolts to lock into place. Grill Body Assembly Cart Frame ...

inserting pre-attached bolts on side burner into the keyholes on the front panel. Tighten bolts securely. Step 9 Attach front panel to left side table by inserting pre-attached bolts on the side table into the keyholes on front panel. Tighten bolts securely. Pre-attached Bolts Pre-attached Bolts ...

side of control panel. Attach the side table assembly to the left side of firebox. Place table over bolts and slide toward back of grill, then tighten securely. Attach left side table front panel to grill body using the removed M6 X 12 mm bolt. Step 11 Remove M6 X 12 mm bolt from right side of control panel. Attach th ...

bolts on the burner assembly bracket before performing Step 12. Step 12 Insert the side burner valve assembly through the holes in the side burner front panel, then firmly seat the valve nozzle into the burner venturi. Rotate burner valve assembly counterclockwise to lock in place with keyho ...

backside of grill. Hang grease cup from brackets on bottom of grease tray. Step 16 Place the heat distribution plates on lower level of grill body assembly directly above burners. Step 17 Place cooking grates on support ribs directly above heat distribution plates. Step 18 Place warming rack in brackets so that it ...