Brinkmann Smoke'n Pit Owner's Manual

NOTICE TO INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE GRILL OWNER FOR FUTURE REFERENCE. OWNER’S MANUAL ASSEMBLY AND OPERATING INSTRUCTIONS WARNING READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS IN THIS MANUAL TO AVOID PERSONAL INJURY OR PROPERTY DAMAGE. MANUAL DEL PROPIETARIO INSTRUCCIONES DE ARMADO Y OPERACIÓN SA ...

the grill. Never use on wooden or other surfaces that could burn. • DO NOT use grill without charcoal tray in place. DO NOT attempt to remove charcoal tray will tray contains hot coal. • Proper clearance of 10 f ...

contents will be hot. • When grilling, grease from meat may drip into the charcoal and cause a grease fire. If this should happen close lid to suffocate the flame. Do not use water to extinguish grease fires. • Use cauti ...

2 Right Legs 2 Left Legs 1 Shelf 1 Axle 2 Wheels 2 Wheel Caps 2 Leg Braces 1 Firebox Support 1 Grill Base 1 Front Shelf 2 Front Table Supports 1 Charcoal Tray 1 Charcoal Grate 2 Charcoal Grate Adjusters 3 Cooking Grills 1 Warming Rack 1 Grill Lid 1 Smokestack Bracket 1 Smokestack 1 Smokestack Damper 1 Spring 1 Temperature Gauge 1 ...

9 M6 Hexagonal Nuts 8 M5 Hexagonal Nuts 2 M6 Cap Nuts 43 M6 X 12mm Phillips Head Bolts 2 M6 Washers 7 M5 X 12mm Phillips Head Bolts 2 M8 X 23mm Phillips Head Shoulder Bolts 3 M6 X 15mm Phillips Head Shoulder Bolts 1 M5 X 12mm Phillips Head Shoulder Bolt 9 8 7 6 5 4 3 2 1 1 2 3 4 6 7 8 9 5 INSTR_810-3040-W_SmokeNPit.qxd 12/28/05 12:53 P ...

friend to help you put your grill together. Lay cardboard down to protect grill finish and assembly area. Turn the grill on its side to begin assembly. Step 1 Connect right (item #1) and left legs (item #2) together (2 pairs). Front pair legs will have 2 extra holes for front shelf supports as illustrated. Ste ...

flange towards center of grill onto the legs using eight M6 x 12mm Phillips head bolts. Do not tighten bolts until Step 6 is completed. NOTE: Leg brace with two holes for grease cup holder must be mounted on right side of grill legs. Step 5 Install firebox support bracket (item #8) onto the holes on the left ...

grill base using two M6 x 12mm Phillips head bolts. Attach table supports (item #11) with slotted holes towards front shelf using four M6 x 12mm Phillips head bolts. Step 8 Attach push handle (item #27) onto firebox lid (item #25) using two M6 x 12mm Phillips head bolts. Step 9 Attach smaller handle (item #2 ...

M5 x 12mm Phillips head bolt and M5 nut. Step 11 Attach air shutter (item #31) onto firebox door (item #30) using one M6 x 12mm Phillips head bolt and M6 nut. Do not overtighten air shutter, air shutter should move freely. Attach door latch (item #33) using one M5 x 12mm Phillips head shoulder bolt and M5 ...

base (item #34) using six M6 x 12mm Phillips head bolts. Step 14 Connect firebox and grill base (item #9) together using six M6 x 12mm Phillips head bolts. Step 15 Connect firebox support (item #8) with firebox base (item #34) using two M6 x 12mm Phillips head bolts and M6 nuts. 9 INSTR_810-3040-W_SmokeNPit. ...