A-Star 2018 ED Installation Programming Troubleshooting

SOFTENER PROPERLY VOIDS THE WARRANTY. • BEFORE YOU BEGIN INSTALLATION, READ THIS ENTIRE MANUAL. THEN, OBTAIN ALL THE MATERIALS AND TOOLS YOU WILL NEED TO MAKE THE INSTALLATION. • CHECK LOCAL PLUMBING AND ELECTRICAL CODES. THE INSTALLATION MUST CONFORM TO THEM. IF I ...

The softener is shipped in one master carton. The softeners are completely assembled at the factory, except as required at installation. Be sure to check the entire softener for any shipping damage or parts loss. Also note damage to the shipping cartons. Contact the transportation company for all damage and loss claims. The manufactu ...

52 @ 0.8 86 @ 1.7 Rated Capacities @ salt dose (°Fm³@Kg) 122 @ 4.6 Resin Quantity (Liters) 18 Rated Service Flow (L/min) 26 pressure drop @ service flow (BAR) 0.6 Max Flow rate to the drain (l/min) 11 Max hardness (°F) 162 Max Clear water Iron ( PPM) 5 Tank Size ( inch) 10*21 Valve connections (inch) 3/4 Capacity salt tank ...

WHERE TO INSTALL THE SOFTENER o Place the softener as close as possible to the pressure tank (well system) or water meter (city water). o Place the softener as close as possible to a floor drain, or other acceptable drain point (laundry tub, sump, standpipe, etc.). o Connect the softener to the main water supply pipe BEFORE or ...

You must first decide how to run in and out pipes to the softener. Look at the house main water pipe at the point where you will connect the softener. Is the pipe soldered copper, glued plastic, or threaded galvanized? What is the pipe size? Now look at the typical installation illustration below. Use it as a guide wh ...

cover forward and lift up. 1. INSTALL BYPASS VALVE: o Remove the plastic shipping plug and wire from valve outlet. o Push the bypass valve (lubricate o--ring seals)into both ports of the valve...Figures 3A. o Snap the two large plastic clips in place, from the top, down...Figures 3A and ...

o To maintain electrical ground continuity in the house cold water piping, install the ground clamps (not included) as shown. Be sure the pipes are clean, under the clamps, to assure good contact. NOTE: A 3-valve bypass system maintains ground continuity. 5. PLUMB IN AND OUT PIPES TO AND FROM SOFTENER: CA ...

get to the drain point, do not raise higher than 2.4 meters above the floor. Elevating the hose may cause a back-pressure that could reduce brine draw during regenerations. CONNECTING A RIGID VALVE DRAIN TUBE o To adapt a copper drain tube to the softener, use a hacksaw to cut the barbed end from the dra ...

TO OBSERVE PREVIOUS CAUTION NOTES. H. Turn on the gas or electric supply to the water heater. Light the pilot, if applicable. 9. ADD WATER AND SALT TO THE BRINE TANK: o Slide open the salt storage area cover. Add about 10 liters of water into the tank. DO NOT ADD INTO THE ...