Code Soft MD2 Series Operation & User’s Manual

especially for the RS-232 interface cable. NOTICE: 1. All software, including firmware, furnished to the user is on a licensed basis. 2. The right is reserved to make changes to any software or product to improve reliability, function, or design. 3. The material in this manual is subject to change ...

Default setting for each barcode... ...

iii Code 11.................................................................................................................................................................44 MSI/Plessey..........................................................................................................................................................45 UK/Plessey ...... ...

Input voltage 5 VDC ± 0.25V Power 500 mW (Operating); 650 mW (Max.) Current 100 mA (Operating); 130 mA (Max.) Standby current <250μA Laser 645-660nm laser diode Decoding rate 200 times/sec Scanning angle ±60°, ±65°, ±42° (Skew, Pitch, Roll) Print contrast 25% minimum reflection difference ...

Cable connector interface pin-outs The pin-outs descriptions in Table 1 apply to the cable connector on the scanner and are for reference only. Table 1-2 Cable connector pin-outs descriptions Pin RS232 Keyboard (PS2) USB 1 Power (+5V) Power (+5V) Power (+5V) 2 +3.3V ( for interface auto selection purpose) Ground (for i ...

Table 2 Default setting for each barcode Code type Read enable Check digit verification Check digit transmission Min. code length Proprietary code ID AIM code ID UPC-A √ √ √ (12)2 A ]Em UPC-E √ √ √ (8)2 D ]Em UPC-E1 √ √ √ (8)2 D ]Em EAN-13 √ √ √ (13)2 A ]Em EAN-8 √ √ √ (8)2 C ]Em ISBN (Bookland ...

Figure 1 ① LED ② Exit window ③ Trigger ④ Cable interface port ⑤ Release-hole of the cable ⑥ Beeper Figure 2 Remove the interface cable: 1. Find the release-hole. 2. Insert a thin wire into the hole and pull out the cable gently. ...