Code Soft s4 Operation & User’s Manual

I Table of contents 1. Introduction............................................................................................................1 1.1 In the box......................................................................................................1 1.2 Printer Features .......................................... ...

II 7. Specifications......................................................................................................43 7.1 General specifications ............................................................................43 7.2 Universal Serial Bus (USB) port pin assignment.............................45 7.3 Serial po ...

III About this user’s manual This user’s manual is described with a large quantity of illustrations, let the users understand, step by step, how to work this printer to its best. This manual includes also the troubleshooting section which could provide a pre-way to eliminate or find out the troubles, without the help of ...

1 1. Introduction 1.1 In the box After unpacking, please inspect carefully and make sure that you receive all the necessary parts as below:  Printer  Power supply  Power Cord (varies by country)  Software CD ROM  Quick start guide  USB cable If any parts are missing, please contact the service department of ...

3 1.2.3 Interior view Media roll holder Media guide Adjustable media gap sensor Platen roller Cover-up sensor Media holder lock latch Supply spindles Printhead Array sensors Take up spindles Tear-off blade Dispenser (option) Peel-off roller Peeler sensor Peeler bar Dispenser cover Media sensor ...

4 2. Getting start 2.1 Loading the ribbon 1. Pulling the release latches on two sides toward the front of printer to open the printer cover. 2. Open the ribbon cover by pushing the ribs (as shown in green) of ribbon cover. Do not open the ribbon cover by pushing the cover edge which installed the blade to tear off the label ...

5 3. Insert the ribbon roll to the supply spindle. 4. Rotate the supply hub until the notches align and lock in to the left side of supply hub. ...