LevelOne FUS-3101 Operation & User’s Manual

Some USB devices, like printers or MFPs (multifunction printers), require to install vendor-supplied driver (usually on CDROM). For those USB devices that do not need to install driver, please skip this section. A. Insert the CDROM into the CD drive and run the “autorun” program. B. Follow the instructions of the ...

LevelOne FUS-3101 firmware, you can use the Maintenance tool.  Restart: click this button to restart (reboot) the Server.  Factory Default: click this button, the Server will restore factory default values.  Firmware Upgrade: click Browse to find the firmware file to be upgr ...

LevelOne FUS-3101 G. Now, the installation program will detect the USB device and continue to install driver. H. After the installation is completed, click the USB device in the Control Center and then click the “Disconnect” button to ...

LevelOne FUS-3101 You may restore the Server’s default parameters by one of the following methods. 7.1 Using the Server’s Web Pages 1. Go to the Server’s web page and click CONFIG 2. Enter administrator (default: admin) and password (default: admin). 3. Click Maintenance. 4. Click Factory Default. 5. Click Yes to confirm 7.2 Using In ...

LevelOne FUS-3101 4.1 Introduction The goal of this product is to provide the USB device server in a single product. We developed a new technology called “NetUSB” to achieve this goal. Basically, the “NetUSB” is a “USB over IP” technology that transparently redirects all USB packets to TCP/IP network channel. “NetUSB” al ...

3. Click Submit to save your settings. And the server will reboot 4. You have now finished the procedure of setting the wireless parameters. After properly configuring the wireless parameters, you can remove the network cable and reboot the Printer Server. LevelOne Printer S ...

LevelOne FUS-3101 with your Server. Fault symptoms, possible causes, and remedial actions are provided within a quick reference table. This Server’s USB ports only support MFPs, printers, scanners, mass storage, and USB cameras. 6.1 LED Indicators In ...

LevelOne FUS-3101 CHAPTER1 INTRODUCTION.......................................................................................................3 1.1 About the Printer Server Described in this Manual............................... 3 1.2 Customer Support .................................................................................... 3 CHAPTER2 PRODUCT ...

automatically do a connect operation. Then, the print job will be issued to that printer. G. Even you already properly setup an auto-connected printer, the Control Center must be running (in the background) while a print job is issued. This means you’d better r ...