Bosch DINION 4000 Manuals

1a 1b 2 3 4 24 VAC or 12 VDC class 2 power supply 230 VAC power AWG16 to 22 stranded or AWG16 to 26 solid wire 12 VDC 24 VAC VIDEO + ALARM 1 2 3 4 5 6 5 mm (0.2 in) VIDEO ALARM 1 2 3 4 5 6 12 VDC 24 VAC VIDEO + ALARM 1 2 3 4 5 6 Video BNC 75 Ohm Bosch Bosch Alarm in not used Relay out contact 2 Alarm in ground not used Relay out contact 1 1 2 3 4 5 6 (VBN version only) Bosch Bosch Menu 1s Bosch Back focus Bosch Unlock Focus Focal length Bosch 1 Safety 1.1 Safety precautions DANGER! High risk: This symbol indicates an imminently hazardous situation such as "Dangerous Voltage" inside the product. If not avoided, this will result in an electrical shock, serious bodily injury, or death. WARNING! Medium risk: Indicates a potentially hazardous situation. If not avoided, this could result in minor or moderate bodily injury. CAUTION! Low risk: Indicates a potentially hazardous situation. If not avoided, this could result in property damage or risk of damage to the unit. CAUTION! The Low Voltage power supply unit must comply with EN60950 / UL60065. The power supply must be a SELV-LPS unit or a SELV - Class 2 unit (Safety Extra Low Voltage - Limited Power Source). CAUTION! Installation should only be performed by qualified service personnel in accordance with the National Electrical Code NEC800 (CEC Section 60) or applicable local codes. 1.2 Important safety instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Install in accordance with the manufacturer's instructions. 8. Do not install unit near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 10. Only use attachments/accessories specified by the manufacturer. 11. Unplug this apparatus during lightning storms or when unused for long periods of time. 12. Refer all servicing to service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. 1.3 FCC & ICES compliance FCC & ICES Information This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: – reorient or relocate the receiving antenna; – increase the separation between the equipment and receiver; – connect the equipment into an outlet on a circuit different from that to which the receiver is connected; – consult the dealer or an experienced radio/TV technician for help. Intentional or unintentional modifications, not expressly approved by the party responsible for compliance, shall not be made. Any such modifications could void the user's authority to operate the equipment. If necessary, the user should consult the dealer or an experienced radio/television technician for corrective action. 1.4 Bosch notices Optical elements Optical elements are sensitive and should be protected at all times. Do not allow objects to come into contact with glass surfaces and do not touch optical elements with your fingers. Copyright This manual is the intellectual property of Bosch Security Systems and is protected by copyright. All rights reserved. Trademarks All hardware and software product names used in this document are likely to be registered trademarks and must be treated accordingly. Note Bosch Security Systems accepts no liability for damage resulting directly or indirectly from faults, incompleteness or discrepancies between the user guide and the product described. More information For more information please contact the nearest Bosch Security Systems location or visit www.boschsecurity.com Disposal - Your Bosch product was developed and manufactured with high-quality material and components that can be recycled and reused. This symbol means that electronic and electrical appliances, which have reached the end of their working life, must be collected and disposed of separately from household waste material. Separate collecting systems are usually in place for disused electronic and electrical products. Please dispose of these units at an environmentally compatible recycling facility, per European Directive 2002/96/EC DINION 4000 - Quick Install AM18-Q0643 1/2

Power Alarm Audio In CVBS Ethernet (PoE) Audio Out 6 x 25 x4 4 x 25 x4 DINION IP bullet 4000 / DINION IP bullet 5000 NTI-40012 | NTI-50022 Safety Instructions de deutsch en english es español fr français zh-CHS 中国语文 CHS microSD card (not included) Menu Reset Video out (service) x4 x4 70 (2.76) 70 (2.76) mm (in) Ø37 (1.46) Ø6 mm 6 x 25 RJ45 Ethernet (PoE) DHCP (no DHCP: 192.168.0.1) STP Cat5e Ethernet (PoE) 24 VAC / +12 VDC SELV Class 2 Power Supply PoE Earth 7 mm (0.3 in) 24-28 AWG Power Color Brown - Alarm NO Yellow - Alarm COM Blue - Alarm IN Grey - Alarm GND 10 kOhm typ. 0.707 Vrms 16 Ohm typ. 0.707 Vrms Alarm Audio In Audio Out Red - Audio 0ut Black - GND White - Audio In Black - GND CVBS 75 Ohm BNC male (F.01U.344.031 SPP BNC Cable. IP Bullet 4K 5K) BNC female Video Out x4 4 x 25 Tilt 90° Twist 360° Pan 360° Menu CVBS On Default Focus Zoom OK Zoom (0-6) Focus & Zoom OK - autofocus - autofocus >2s >2s <2s <2s <2s <2s <2s <2s <2s Analog format <2s Output OK 1 2 3 4 5 10 6 7 8 9