OPTEX FA D2RF Series Manuals

Instruction Manual Digital Fiber Amplifier D2RF/D2GF Series D2RF-TAN Analog Output Model D2RF-TAP Thank you for purchasing the D2RF Series. We hope you are fully satisfied with this product and enjoy it's performance. Carefully read this instruction manual and keep it for future reference. Safety Precautions Carefully read and understand the safety precautions before operation. The important information is provided to protect your health and property. Do not apply any other installing or operating procedure other than that described in this manual. CAUTION It is dangerous to wire or attach/remove the connector with the power on. Make sure to turn off the power before operation. Make sure to use the product with the protective cover attached and closed. Installing in the following places may result in malfunction: 1. A dusty or steamy place 2. A place generating corrosive gas 3. A place directly receiving water or oil mist. 4. A place that is subjected to heavy vibration or impacts. The product is not designed for outdoor use. Do not use the sensor in transient state after power on (approx. 100 ms). Do not wire with the high voltage cable or the power line. Failure to do this will cause malfunction by induction or damage. The sensor performance or digital display values may depend on the individual units or the condition of detected product. This product is not an explosion-proof construction. Do not use the product in a flammable, explosive gas or liquid environment. Do not use the product in water. Do not disassemble, repair, or convert the product. Failure to do this may cause failure, fire, or electric shock. Operate within the rated range. This product cannot be used as a safety device to protect human body. Model Analog Output Cable type D2RF-TA (N/P) Power source, voltage 12-24V DC ±10% including ripple Consumption current 45mA or less / 24V (When not using analog output) Response time 60 �s / 250 �s / 2 ms (Fast/Standard/Long) Control output NPN / PNP Open collector 100mA / 30V or less Load current: 100mA or less Residual voltage: 1.8V or less Output method Selectable Light on / Dark on Short-circuit protection Incorporated Light source Red LED Indicator light / Display Output Indicator: Orange / 7 segment / 8 digit display Sensitivity setting Teaching / Manual adjustment Timer function OFF, On delay timer, Off delay timer, One-shot timer Timer time 1ms - 9 sec. Analog Output 4 to 20 mA Operating temperature/humidity -25 ~ +55 C / 35 ~ 85% RH o No freezing and No condensation Store temperature/ humidity No freezing and No condensation Shock resistance 10 ~ 55Hz Amplitude 1.5mm 2 hours for each direction of X,Y and Z Protective category IP50 Material Case: PPE, Cover: PC Weight 70g (Including cable) Part Description Mounting Amplifier Attaching to and Removing from DIN rail Attaching the amplifier. Attach the front of the amplifier onto the DIN rail or mounting bracket. Press the back of the amplifier down until it snaps into place. Amplifier removal. Push the amplifier in the direction of , lift the front of the sensor and remove. -40 ~ +70 C / 35 ~ 85% RH o How to connect the fiber cables Open fiber lock lever. Insert fiber into holes to stop. Approximately 15mm guided by fiber sign Return fiber lock lever until it stops. When using diffuse reflection co-axial fiber cables the cable with the single core or white line is the emitter, the multi-core fiber is the receiver. How to use Fiber Adapter Turn adapter cap completely counter-clockwise, then insert the fiber. Lock the cable by turning adapter cap clockwise. Cut the excess fiber with fiber cutter. CAUTION Adapter cap Cut position Fine fiber Optex-FA U.S. sales Ramco Innovations (800) 280-6933 www.optex-ramco.com