OPTEX FA D2RF Series Instruction Manual

D2RF/D2GF Series D2RF-TAN Analog Output Model D2RF-TAP Thank you for purchasing the D2RF Series. We hope you are fully satisfied with this product and enjoy it's performance. Carefully read this instruction manual and keep it for future reference. Safety Precautions Carefully read and understand the safety precautions before operation. The important information is provided to protect your health and property. Do not apply any other installing or operating procedure other than that described in this manual. CAUTION It is dangerous to wire or attach/remove the connector with the power on. Make sure to turn off ...

Press the teaching button. T Setting Maximum Sensitivity Switch to SET. SET RUN The threshold value flashes and the display returns to normal. Switch to RUN. Reflective type: Perform the adjustment without an object present. Thru-beam type: Perform the adjustment with an object present. SET RUN SET RUN Single Point Teaching Switch to RUN. Switch to SET. SET RUN Select Single-point teaching. Press the teaching button. T The threshold value flashes and the display returns to normal. Reflective type: Perform the adjustment on the background without an object present. The threshold is set to 5% more than the ...

Select by using and set with . Standard setting 500 μs High accuracy setting 2 ms Fastest setting 60 μs 2. Response speed setting TOP Select the operation mode. Select by using and set with . ON when light is blocked. ON when light comes in. 1. Operation setting TOP Select the type of timer and the time value. Timer Time Setting 1-9000 (1 ms - 9 sec.) Select by using and set with . OFF returns to the TOP of Timer setting, other choices continue on to Timer setting. is for time changing, is for digit change, and is to set. Off delay timer Timer off On delay timer One shot timer 3. Timer setting TOP Correct the sensit ...

Manual Adjustment Error Display in Teaching An error message is displayed in the event of error during adjustment. Refer to the table below for readjustment. * No operation state for 5 seconds during setting automatically returns the display to normal as well. Normal Automatically returns to the normal display 5 seconds after completion of the setting (no operation). When using zone teaching Setting Lower Limit (Far) Indicates shortage of light intensity or no difference of light intensity. Indicates a sampling error in teaching of a moving object. Indicates a calculation error. Indicates that the teaching process was ...

End Unit D2RF-TA (Unit: mm) Maximum aperture 150 Backside of bracket Website http://www.optex-fa.com 0537450 Specifications and equipment are subject to change without any obligations on the part of manufacture r. For more information, questions and comments regarding products, please contact us below . Head office: Mitsui Seimei Kyoto Yamashina BLDG 6F, 46-1 Takehanadounomae-cho, Yamashina-ku, Kyoto 607-8085 Japan TEL: +81-(0)75-594-8123 FAX: +81-(0)75-594-8124 Manufactured and sold by : 16.3 55.4 18.8 27.8 34.8 5.6 7 4.3 10 68.9 2.6 3 14 33.4 10.5 32 7.8 9.4 8 O 7.6 2- O 2.2 2- R2.1 n4.2 9 3 2-R1.6 2-R1.6 9 ...