Loc8tor Lite Operation & User’s Manual

Text of the manual

Manual del Usuario, Mode d’Emploi

Bedienungsanleitung English 2 Español 15 Français 30 Deutsch 44 Pack Contents: 1x Loc8tor Lite, 2x Mini Homing Tags 1x Mounting Bracket, Tag ID Sticker Key Ring Loop, Adhesive Strips Page

Thank you for purchasing a Loc8tor Lite, the great new

product that guides you to your mislaid valuables even in those hard to find places. The Loc8tor Lite has been designed to be versatile and easy to use, whether at home, out and about or in business. Please take a few minutes to read through this User Guide to help you get the most out of yo

Switching ON / OFF

6 Volume 6 Locating – Find a mislaid item 7 Range Guidelines 9 Mounting Bracket 9 Batteries 10 Unregister / Deleting a Tag 11 Warranty 12 General Care 13 Please note 13 On / Off (hold in for two seconds) Volume Register and Locate up to four Tags Directional lights Status Light Button Guide Pa

Your Loc8tor could not be easier to setup or use. Follow

these steps and you’ll be tracking down your tagged valuables in no time at all. 1. ACTIVATE BATTERIES Pull out the strip on the back of the Loc8tor to activate battery. It will beep and all the lights will flash – It is now ON. * * After approx. 45 seconds left idle your Loc8tor

3. ATTACH TAG

Adhesive strips: Best used when attaching to a clean, dry, hard, flat surface. Peel off backing to attach. Sticky tabs are not permanent but increase their bond with time. Ideally leave for a minimum of 10 minutes. Strongest bond after 24 hours. To remove insert flat tool under Tag and gently twist to prise off. Key ring loop: Use to attach T

SWITCHING ON / OFF

ON Hold in the right hand side button (see Button Guide) • for 2 seconds. The Loc8tor will bleep and all the lights flash. Small status light will flash whilst on. • The Loc8tor will automatically power down after 45 • seconds if left idle. OFF Hold in the right hand side button for 2 seconds. Loc8tor • will beep and turn off. VOLU

LOCATING – FIND A MISLAID ITEM

LOST Press and hold down the ON button until the Loc8tor • beeps and lights flash. Press the button that your item / Tag is allocated to. • Loc8tor will beep and status light will flash rapidly as it’s • searching for the Tag. When a Tag is detected the locating • lights will light up and the audio will start. With

Place the Tag on a surface and practice locating a few

• times to get a feel for how it works. If you are ever unsure which direction to go in slowly • repeat full 360° circle and then go in the direction with the strongest signal strength. Strongest signal is displayed when the Loc8tor is • pointing directly at Tag. Try moving Loc8tor

Range will vary greatly depending on where the Tag

is used and what it’s attached to. If higher up and with a clear line of sight, items can be found in excess of 122m/400feet. The chart gives a guideline. Actual range may differ significantly as performance is affected by type of application and environment it’s used in. Tortoise 30m

Other Remote Control Manuals