Sarabec Loop System LA240 Operation & User’s Manual

easily to their TV or Audio equipment via the “T” or “Loop” facility of their hearing aid. With no direct connection between the user and a TV or Audio equipment the user is able to move freely within the looped area and listen comfortably to a TV or audio equ ...

2. Keep these instructions for future reference. 3. Do not use the system or accessories near water. 4. Do not expose the system or accessories to rain or any other source of moisture. 5. Should the amplifier require cleaning only do so with a dry cloth. 6. Ensure that there is enough ...

gned to be used with modern audio and video products to transmit the sound direct to your hearing aid. Your hearing aid must be switched to the “T” or Loop function to use the loop system. You can also enjoy the benefits of the loop amplifier by s ...

Run the loop cable around the room starting and ending at the amplifier. The cable may be tucked under the edge of the carpet, or fixed to either a picture / dado rail or skirting board with the clips provided. Where the cable passes a door or other obstacle, either fix the cable around the frame or tuck under the car ...

When the loop cable connector (11) buttons are pushed in a hole will appear. Push the bare wire into the hole. Ensure that only the bare wire and not the plastic insulation goes into the hole, then release the button to lock the cable in place. Connect Audio Inputs from TV or other Audio Source to Loop Amplif ...

lead to the power supply and then plug into a mains outlet. Switch on the power at the outlet. This amplifier may also be used with DC power supplies directly connected to the amplifier such as those found in buses and coaches. Operation When connecting po ...

position in use. Loop level Indicator (3) This indicates that a signal is being transmitted by the loop cable. It flickers with a low volume and remains steady with louder volumes. Testing the system can be done by speaking into a microphone and seeing the light ...

described with the addition of a mute function for the volume. ...

Symptom Possible cause and remedy No sound • Re check all connections. • Amplifier not switched on. Switch on at mains socket. Press mains switch. Check blue light is on. • Microphone or audio source not connected or selected. • Hearing aid not on the ”T” or loop program. Low sound • Microphone too far from sound. • Loop ...