Danfoss 176F6494 Installation Instructions Manual

VLT® HVAC Drive FC 102, VLT® AQUA Drive FC 202, and VLT® AutomationDrive FC 302 D4h-size VLT® Parallel Drive Modules mounted in a Rittal TS8 enclosure. The kit directs air in from the back of unit and out through the top of the unit. See Illustration 1.1. 1 Back-channel airflow (exh ...

• Base mounting plate, 38 mm (1.5 in.) (4) • Gasket, base mounting plate (4) • Duct spacer (2) • Gasket, between exhaust and backplate (2) • Gasket, between duct spacer and cabinet panel (2) • Gasket, between duct spacer and backplate (2) • Slot gasket, between drive module and backplate (2) • M5 nuts (20) • Scre ...

Refer to Illustration 1.4 for the following steps. 1. Cut out the intake openings in the mounting backplate. The openings must match to the intake vent openings of the drive module. 2. Drill the 12 screw holes around the vent openings and insert the 12 M6 X 12 pem studs, with the studs facing toward the back o ...

The front cover gasket (10) and front cover plate (9) are not installed during the lower duct assembly. They are installed once the duct is attached to the mounting backplate. 1. Install the left and right side gaskets (6) against the back side of the duct enclosure (11). 2. Place the grill (7) on top of the gaskets. Secur ...

1. On the top side of the enclosure, install the gasket (7) and then the grill (2). Secure the grill with 8 M5 nuts and torque to 5.1 N · m (45 in-lb). 2. Install the gasket (1) on top of the grill. Leave the paper backing on the adhesive until ready to install on the drive module. 3. Turn the duct enclosure over so the ba ...

1. Install the mounting backplate to the cabinet rails, making sure that the pem studs/nuts are facing toward the back of the enclosure. 2. Install gaskets to the back side of the drive module. Refer to Illustration 1.7. 2a Install gasket (9) over the vent opening. 2b Align the slot gasket (10) with the lower mounting holes in the ...

2 Upper duct assembly 6 Intake vent opening 3 Upper mounting point for drive module (M10 pem nut) 7 Gasket, between back exhaust and mounting backplate 4 Mounting backplate 8 Slot gasket Illustration 1.7 Installing the Drive Modules onto the Mounting Backplate Installation Instructions In-b ...

Refer to Illustration 1.8 for the following steps. 1. Remove the paper backing from the top plate gasket. 2. Place the lower duct assembly up against the drive module base, making sure the mounting holes line up. 3. Secure the lower duct assembly to the base of the drive module using 7 M5x16 screws ...

1. Cut out the 2 exhaust vent openings in the top panel cover. The openings must match to the exhaust vent openings on the upper duct assembly. Refer to Illustration 1.9. 2. Secure the top panel cover to the frame. Illustration 1.9 Vent Dimensions for the Top Panel Cover Installing the Back Cover Panel 1. Install a gasket (2) a ...

order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed. All trademarks ...