Fluke 1736 Instructions Manual

©2015 Fluke Corporation. All rights reserved. Specifications are subject to change without notification. All product names are trademarks of their respective companies. Auxiliary Input Adapter for 17xx Power and Energy Loggers Instructions Introduction The Auxiliary Input Adapter (or Product) is an accessory for the 17xx Power and ...

dangerous to the user. A Caution identifies conditions and procedures that can cause damage to the Product or the equipment under test. XW Warnings To prevent possible electrical shock, fire, or personal injury: • Read all safety information before you use the Product. • Carefully ...

personal protective equipment (approved rubber gloves, face protection, and flame-resistant clothes) to prevent shock and arc blast injury where hazardous live conductors are exposed. • Do not use the Product around explosive gas, vapor, or in damp or wet environments. • Limit operation to the specifie ...

X WARNING. HAZARDOUS VOLTAGE. Risk of electric shock.  Consult user documentation. T Double Insulated  Earth  Measurement Category II is applicable to test and measuring circuits connected directly to utilization points (socket outlets and similar points) of the low-voltage MAINS installation. � ...

To connect the Adapter: 1. Make sure that all 4 mm safety test leads are disconnected. 2. Loosen the 4 captive screws  and remove the lid  to open the housing. 3. Cut and strip the cable. 4. Open the grommet strain relief  and remove the dummy plug D. Note The dummy plug or a cable must be installed to ac ...

The cable diameter must be in the range of 3 mm to 6 mm to ensure proper strain relief. 6. Tighten the strain relief. 7. To connect the wires to the terminals E, press the opening lever. 8. Correctly orient the lid  and close the housing. 9. Tighten the captive screws . Note Pay attention to the ...

Clean the Product with a soft cloth, mild soap, and water. W Caution To avoid damage, do not clean with abrasives or solvents. Specifications General Calibration Cycle ................ 2 years Warranty............................. 1 year Dimensions......................... 119 mm x 86 mm x 38 mm (4.69 in x 3.39 in x 1.5 in) Weight .............. ...

Voltage Divider Input.........150 ppm/°C (for temperatures <18 °C and >28 °C) Safety Direct Input Maximum Voltage between Direct Input Terminals and Earth Ground.................. 30 V Voltage Divider Input Maximum Voltage between 4 mm Safety Socket and Eart ...

+ - Direct Input / 10V + - Terminal blocks 10M AUX1 10M + - + - 10M 173x Auxiliary Input AUX1 Safety plugs Voltage Divider Input / 1000V Direct Input / 10V Terminal blocks AUX2 Safety plugs Rin = 2.92M AUX2 511k 511k 289k 511k 511k 289k Voltage Divider Input/1000 V Safety plugs Direct Input / 10 V Voltage Divid ...

This Fluke product will be free from defects in material and workmanship for one year from the date of purchase. This warranty does not cover fuses, disposable batteries, or damage from accident, neglect, misuse, alteration, contamination, or abnormal conditions of operation or handling. Resellers are not authoriz ...