Icom IP100H Demonstration Setup Manual

IP100H / IP1000C / IP100FS Demonstration Setup Guide ...

based on the IP100H’s firmware Revision 1.02 and IP1000C’s firmware Revision 1.02. If you have any questions about this guide, please contact your local Icom distributors. Guide Revisions Icom reserves the right to make changes to ...

SECTION 2 SETTING EXAMPLES .......................................................................................................... 2 2-1 STAND ALONE NETWORK CONNECTION AND IP ADDRESS SETTINGS ....... ...

IP1000C IP100H (2 units) Access point • IEEE802.11a/g • Recommendation: Optional AP-90M PC With one of the following OSs installed. • Windows 8 (32/64bit) • Windows7 (32/64bit) • Windows Vista(32bit) (Home Premium / Professional / Ultimate (or e ...

STEP 1: CONNECTION EXAMPLE See each equipment’s instruction manual for connection details. SECTION 2 SETTING EXAMPLES 2-1 STAND ALONE NETWORK CONNECTION AND IP ADDRESS SETTINGS IMPORTANT! We recommend that you connect the access point, IP1000C and PC in a stan ...

Set your access point’s IP address to 192.168.0.50, and SSID to WAVEMASTER-0. [RECOMMENDATION] We recommend that you set the access point’s authentication as follows: For example: • Authentication: WPA-PSK·WPA2-PSK • Encryption Type: TKIP·AES • PSK: 5cf97dgh6 STEP 3: IP1000C SETTINGS Settin ...

STEP 3-4 The IP100H (TR 2) settings [Confirm the IP100H (TR 1 and TR 2) settings] Click Click Enter Enter Click Confirm ...

BEFORE you use a CS-IP100H, the following procedures are required. See the CS-IP100H and OPC- 478UC instruction manuals for setting and installation details. • Install the CS-IP100H (Cloning software) • Install the OPC-478UC (Cloning cable)’s USB driver � ...

Enter the same SSID as the access point Enter the same PSK as the access point (Enter “5cf97dgh6” here) Select IP1000C’s setting screen ...