Emec MTOWER PLUS Series Operating Instructions Manual

Text of Emec MTOWER PLUS Series Operating Instructions Manual

Read Carefully !

ENGLISH Version R12-01-18 OPERATING INSTRUCTIONS F O R “MTOWER PLUS” INSTRUMENT This manual contains safety information that if ignored can endanger life or result in serious injury. They are indicated by this icon. Keep the instrument protected from sun and water. Avoid water splashes. CD/PH/RH Version all-guides com

GENERAL SAFETY GUIDELINES

In emergencies the instrument should be switched off immediately! Disconnect the power cable from the power supply! When installing always observe local regulations! Manufacturer is not liable for any unauthorized use or misuse of this product that may cause injury, damage to persons and / or materials. Caution! Instrument

The “MTOWER PLUS” is a fully featured cooling towers controller with two-way biocide options and inhibitor / bleed

control.Cooling towers are heat removal devices used to transfer process waste heat to the atmosphere. Cooling towers may either use the evaporation of water to remove process heat and cool the working fluid to near the wet-b

Unplug instrument from main power supply then perform connections to probes and / or selected outputs by following

the above picture. For easy understanding board has been divided into two parts: Power connections and I/O connections. Power Connections: F1: General fuse (6.3AT) F2: Circuit fuse (3.15AT) Main power supply (from 90VAC

Standby / Proportional Outputs:

1: - D1 mV (Biocide1) 3: - Biocide2 5: - Pre-biocide1 7: - (Cl) 9: - pH 11: - Inhibitor 2 + D1 mV (Biocide1) 4: + Biocide2 6: + Pre-biocide1 8: + (Cl) 10: + pH 12: + Inhibitor mA outputs (500 Ohm max resistive loa

Cooling tower basic knowledge.

What is a (wet, atmospheric) cooling tower? A cooling tower is a heat rejection device, which extracts waste heat to the atmosphere though the cooling of a water stream to a lower temperature. The type of heat rejection in a cooling tower is termed “evaporative” in that it allows a small portion of the water being cooled

Emec Controller Owners Instructions: