Emec JA Series Operating Instructions Manual

Text of Emec JA Series Operating Instructions Manual

OPERATING INSTRUCTIONS FOR

“JA SERIES” / “JA SERIES PRO” CONTROLLERS This manual contains safety information that if ignored can endanger life or result in serious injury. They are indicated by this icon. Keep the controller protected from sun and water. Avoid water splashes. Read Carefully ! ENGLISH Version R19-07-19 all-guides com

GENERAL SAFETY GUIDELINES

In emergencies the controller should be switched off immediately! Disconnect the power cable from the power supply! When installing always observe local regulations! Manufacturer is not liable for any unauthorized use or misuse of this product that may cause injury, damage to persons and / or materials. Caution! Controller

JA SERIES is a microprocessor based digital controller for conductivity** or pH or Redox or chlorine or temperature

(see controller’s label for bought model) with temperature reading, mA module and native modbus. On/Off, impulsive proportional and PID are main working modes. Working ranges for Conductivity are from 0nS to 9999S with automati

Mainboard Connections JACD and JACD PRO series

Unplug controller from main power supply then perform connections by following the picture below. DC Version Model: 1(-) - 2(+): 12 or 24VDC (see controller’s label) AC Version Model: L(Live) - N(Neutral): 85÷264VAC or 18÷36VAC 50/60 Hz (see controller’s label) 3(Common) - 4(N.O.): Setpoint 1 Output (fre

9 10 11 12 13 14 15 16

17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 L1 N2 3 4 5 6 7 8 Connections for JAPH / JARH / JACDIND / JACL / JASCL / JATEMP and PRO series Unplug controller from main power supply then perform connections by following the picture below. DC Version Model: 1(-) - 2(+): 12 or 24VDC (see cont

When into normal operating mode, JA SERIES shows the following main screen:

TEMPERATURE (1) READING (2) OPTIONS (3) Main screen zones: (1) TEMPERATURE Temperature read by PT100 probe. (2) READING Values read by the probe. “mS” - “uS” - “PPM/TDS”* are the measuring unit for Conductivity probe. To change unit refer to “GENERAL OPTIO

Emec Controller Owners Instructions: