Longrun 610TC Operation Manual

Text of Longrun 610TC Operation Manual

THYRISTOR CO2/MAG ARC WELDER

OPERATION MANUAL DO NOT INSTALL, OPERATE OR MAINTAIN THIS MACHINE WITHOUT READING THIS MANUAL AND PLEASE ALWAYS THINK BEFORE YOU ACT. www.worldwel.com

■ TECHNICAL SPECIFICATIONS

- Stable and excellent welding by new control circuit - Easy to maintain and repair by simple and firm structure design - High duty cycle by sufficient capacity of all parts and quality cooling fan - Adjustable crater voltage and current ITEM UNIT SPECIFICATION Input Voltage V 220, 380, 440, 3 Phase 50/60Hz Rated Output Curre

General Safe Practices

■ Wear approved safety glasses with side shields under your welding helmet or face shield and at all times in the work area. ■ When working above floor level, use a safety belt to protect yourself from a fall should you get a shock. ■ Do not install or place machine on or over combustible surfaces. ■ Be sure that al

Arc rays can burn eyes and skin.

■ Use welding helmet with correct shade of filter to protect your eyes from sparks and the rays of the arc. ■ Wear welders cap and safety glasses with side shields. Use ear protection when welding out of position or in confined spaces. Button shirt collar. ■ Wear complete body protection. Wear oil-free protective clo

● The welding machine shall be installed at a place ;

․ free from the inflammables ․ less humidity, dirt and dust ․ protecting from influence of direct sunlight, wind and rain ․ not generated oil vapor and corrosive gas ․ operating temperature range is from -10℃ to 40℃ ․ least 30㎝ away from wall and other welding ma

■ FRONT PANEL

1 Power Switch When it is turned on, the cooling fan and all of electrical circuit inside the machine will be operated. 2 Crater Selection Switch It choose the Crater OFF or Crater ON. 3 Welding mode selection Switch - Above : Checking the flow of the gas. - Center : CO2/MAG welding - Bottom : Gouging 4 Crater Current Volume Adjust the cra

Longrun Welding System Owners Instructions: