Longrun 250LD2 Operation Manual

Text of Longrun 250LD2 Operation Manual

INVERTER DC STICK WELDER

250LD2, 300LD2 OPERATION MANUAL DO NOT INSTALL, OPERATE OR MAINTAIN THIS MACHINE WITHOUT READING THIS MANUAL AND PLEASE ALWAYS THINK BEFORE YOU ACT. www.worldwel.com MODEL UNIT 250LD2 300LD2 INPUT VOLTAGE V 220, Single phase FREQUENCY Hz 50/60 INPUT CAPACITY KVA 9 11 NO LOAD VOLTAGE V 80 82 CURRENT RANGE A 20~250 20~300 VOLTAGE RANGE

General Safe Practices

Wear approved safety glasses with side shields under your welding helmet or face shield and at all times in ■ the work area. When working above floor level, use a safety belt to protect yourself from a fall should you get a shock. ■ Do not install or place machine on or over combustible surfaces. ■ Be sure that all installation,

Welding sparks can cause fire or explosion.

Remove fire hazards from the welding area. If this is not possible, cover them to prevent the welding ■ sparks from starting a fire. Remember that welding sparks and hot materials from welding can easily go through small cracks and opening to adjacent areas. Avoid welding near hydraulic lines. When not welding, m

FRONT CONTROL PANEL

● POWER LAMP ① WARNING LAMP ② VOLTAGE REDUCING DEVICE LAMP ③ ④ VOLTAGE REDUCING DEVICE SWITCH AMMETER (DIGITAL DISPLAY) ⑤ ⑥ OUTPUT CURRENT CONTROL

Longrun Welding System Owners Instructions: