Skyjacker D6912ST Installation Instructions

Text of Skyjacker D6912ST Installation Instructions

2006 - 2011

Dodge 1500 4WD 1"- 2.5” Performance Strut Installation Instructions Required Tool List: • Safety Glasses • Metric / Standard Sockets & Wrenches • Spring Compressor • Floor Jack • Jack Stands • Measuring Tape • Torque Wrench www.skyjacker.com I-D6912ST REV2 3-11 Pg 1 Before beginning the installation, thoroughly & completely read these instructions & the enclosed driver’s WARNING NOTICE. Affix the WARNING decal in the passeng

Kit Box Breakdown:

Part #: D6912ST ITEM# DESCRIPTION QTY D6920STS DODGE 1500 STRUT SINGLE 2 STSP2 .467 STRUT SPCR RINGS / QTY4 1 I-D6912ST INST SHEET: D6912ST 1 Front Installation: 1. Secure & properly block the rear tires of the vehicle on a level concrete or asphalt surface. 2. Raise the front of the vehicle from the front center cross member & remove the front ti

9. 06-08 Models: Assemble the new Skyjacker strut assembly by

installing the new Skyjacker coil spring seat, new Skyjacker coil spring pad, new Skyjacker strut end cap, new Skyjacker bump stop, OEM coil, & OEM upper hat on the new Skyjacker strut. Compressor the coil spring & install the upper nut. (See Photo # 6) This will yeild approximately 1" of lift depending on vehicle options. (ie. winch, after market bumper, & etc) Not

Skyjacker D6912ST • After the installation is complete, double check that all nuts & bolts are tight. Refer to the following

chart below for the proper torque specifications. (Do not retighten the nuts & bolts where thread lock compound was used.) • With the vehicle placed on the ground, cycle the steering lock to lock & inspect the steering, suspension, brake lines, front & rear drivelines, fuel lines, & wiring harnesses for proper operation, tight

Skyjacker Automobile Parts Owners Instructions: