Sloan CX Series Installation Instructions Manual

SLOAN CX MANUAL CLOSET AND URINAL FLUSHOMETERS Code No: 0816856 Rev. 2 (8/19) LIMITED WARRANTY Sloan Valve Company warrants its Flushometer to be made of first class materials, free from defects of material or workmanship under normal use and to perform the service for which they are intended in a thoroughly reliable and efficie ...

1. Wall Plate 2. Button & Bracket assembly 3. (2) #10-32 x 3 1/2” screws to secure bracket to valve 4 (2) #8-32 x 7/8” screws to secure plate to Bracket 5. Depth setting tool 6. (4) Plunger, screws & locking nut 7. Allen Key 9/64" 8. Installation instructions 1. Wall Plate 2. Button & Bracket assembly 3. Brac ...

Inlet pipe CL to fin. wall 3 ¼” - 4 ¼” (83 mm - 108 mm) 1½” min. (38 mm) 1½” (38 mm) 1½” (38 mm) 36” (914 mm) 1½” (38 mm) Rear of valve to fin. wall 5.15” - 6.15” (130 mm - 156 mm) FIN.WALL ADA GRAB ...

Piston Assembly Conical Spring Activation Assembly Collar Activation Assembly Removal Screws Adjustment Tool Flush Volume Color I.D. Plug Plunger Mounting Bracket Wall Plate 9/64” Hex Wrench Anti-vandal screw Wall Plate to Mounting Bracket Button Mounting bracket to valve body scr ...

NOT HAVE A MALE THREAD) THREADED SWEAT ADAPTER PIPE A On a 15”-18” length of pipe (not provided), slide threaded sweat adapter (not provided) onto water supply pipe until end of pipe rests against shoulder of adapter. Sweat solder the adapter to pipe (1" copper x 1" NPT fitting). B Re ...

tool. • NOTE: would only be needed for certain ADA water closet installations. • Consult rough-in guide (page 2-3) As needed based on rough-in, pre-bend the adjustable tube to account for side-to-side misalignment of water supply pipe relative ...

FOR REAR SPUD URINALS If needed, trim urinal flush tube Slide 3/4" coupling over urinal flush tube Thread F-28 brass flange onto urinal flush tube. Amount of thread engagement will depend on rough-in. Use provided Loctite to secure F-28 flange in place. Apply Loc ...

Note: Valve is shipped with flow adjustment turned off. A Shut off water: use adjustment tool to turn activation assembly fully clockwise. B Relieve pressure by pressing plunger. Push in activation assembly. C Squeeze tabs on Collar and pull out. D Attached provided 1/4-20 screws to activation assembly. Pull to remove assembly E Rem ...

B Push plunger to activate flush. Adjust water flow as needed to clean the fixture. B A CLOSE OPEN THE FLUSHOMETER IS ENGINEERED FOR QUIET OPERATION. EXCESSIVE WATER FLOW CREATES NOISE, WHILE TOO LITTLE WATER FLOW MAY NOT SATISFY THE NEEDS OF THE FIXTURE. PROPER ADJUST ...

Tighten #8-32 screws at bottom of wall bracket. Metal C-bracket will clamp against wall. E E E E2 Slide wall plate over button. Button will pass through top of opening. Insert #8-32 wall plate to mounting bracket screws into wall plate. Tighten to secure to wall bracket. F G G1 G1 G2 G2 H I J K Choose one of three Plu ...