Satel KNX-DIM21 Manual 

Text of the manual

Universal two-channel dimming actuator

Firmware version 1.01 knx-dim21_en 12/19 SATEL sp. z o.o. • ul. Budowlanych 66 • 80-298 Gdańsk • POLAND tel. +48 58 320 94 00 www.satel.eu

The device should be installed by qualified personnel.

Prior to installation, please read carefully this manual in order to avoid mistakes that can lead to malfunction or even damage to the equipment. Changes, modifications or repairs not authorized by the manufacturer shall void your rights under the warranty. SATEL aims to continually improve the

Features ........................................................................................................................... 2

2. Description ........................................................................................................................ 2 2.1 Load types ..........................................

The KNX-DIM21 module is a universal two-channel dimming KNX actuator that allows

stepless control of light sources up to 300 W per channel. The light can be turned on / off, dimmed down (darker) / dimmed up (brighter), set by using a predefined scene or another function via the KNX bus. The actuator can be used with resistive, inductive and

LEDs to indicate channel status / troubles (

and – green, – red) – see Table 1. LED A / B channel status blocked (startup delay) mains synchronization / load detection no load / unknown load type before detection switched off switched on Trouble type overload overheat voltage trouble hardware failure – OFF, – ON, – flashin

You can also use the buttons to restore factory settings of the module (see “Restoring

the module factory settings”). red LED – ON when a physical address is being assigned by using the ETS program. The address assignment can be activated manually with the button on the enclosure or remotely from the ETS program. programming button

Wiring diagram of module outputs

The module has two independent channels based on two independent circuits with a common neutral point. 2.4 Enclosure The module occupies 4 units on the 35 mm DIN rail. 3. Installation Disconnect power before making any electrical connections. The module is designed for indoor installation, in spaces with

3. Use the connection terminal to connect the KNX bus cable to the module.

The module is supplied with voltage from the KNX bus and requires no additional power supply. 4. Connect a computer running ETS program to the KNX bus and configure the module. To configure the module, you will require a computer running the ETS program version 5.5 o

Other Controller Manuals