Juniper PTX5000 Quick Start Manual

Quick Start September 2017 Part Number: 530-066788 Revision 01 This document describes how to install the Juniper Networks ® PTX5000 Packet Transport Router. Contents Quick Start Description | 3 Step 1: Prepare the Site for the PTX5000 | 4 Rack-Mounting Requirements | 4 Tools Required to Unpack and Install the PTX5000 | 5 Ste ...

Step 8: Connect Power to the PTX5000 Router | 24 Connect Power to the PTX5000 60-A DC Input Power Trays | 24 Connect Power to the PTX5000 120-A DC Input Power Trays | 29 Connect Power to the PTX5000 Three-Phase Delta AC PDUs | 32 Connect Power to the PTX5000 Three-Phase Wye AC PDUs | 36 Connect Power to the PTX5000 High Capacity D ...

This Quick Start contains information you need to install and configure the PTX5000. For complete installation instructions, see the PTX5000 Packet Transport Router Hardware Guide at https://www.juniper.net/documentation/. WARNING: This Quick Start contains a summary of safety warnings in “Safety Warnings” on page 76. For a comple ...

IN THIS SECTION Rack-Mounting Requirements | 4 Tools Required to Unpack and Install the PTX5000 | 5 Before installing the PTX5000, make sure that the site meets all the power, environmental, and clearance requirements. See the site preparation guidelines in the PTX5000 Packet Transport Router Hardware Guide. Rack-Moun ...

front and back of the chassis. At least 24 in. (61.0 cm) are required both in front of and behind the PTX5000. NEBS GR-63 recommends that you allow at least 30 in. (72.6 cm) behind the rack. • Additional clearance is required to accommodate the depth of ...

• Grounding cable (which you must provide) • Grounding lug (depending on your configuration, 0-AWG or 4-AWG (21.2 mm 2) cable lugs are supplied with DC PDUs, and can be used for grounding.) • M6 screws or UNC 1/4-20 screws • Electrostatic discharge (ESD) grounding wrist strap If you have an AC-powered ...

IN THIS SECTION Install the PTX5000 Mounting Hardware for a Four-Post Rack or Cabinet | 7 Install the PTX5000 Mounting Hardware for an Open-Frame Rack | 11 To install the mounting hardware, perform one of the following procedures: Install the PTX5000 Mounting Hardware for a Four-Post Rack or Cabinet 1. Install Ca ...

Rear Support Bracket Four-Post Rack Mounting Shelf Distance Above U Division Hole X X 1.86 U 3.25 in. (8.3 cm) 6 X X 1.5 U 2.63 in. (6.7 cm) 5 X X 1.14 U 2.00 in. (5.1 cm) 4 X X 0.86 U 1.50 in. (3.8 cm) 3 X X 0.50 U 0.88 in. (2.2 cm) 2 X X 0.14 U 0.25 in. (0 ...

Install the Four-Post Mounting Shelf and Rear Support Bracket To install the four-post mounting shelf and rear support bracket (see Figure 2 on page 10): 1. On the rear of each rear rack rail, partially insert a mounting screw into the lowest hole specified in Table 1 on page 8. ...

g006189 2 1 2— 1— Four-post mounting shelf Rear support bracket Remove the Center-Mounting Brackets The center-mounting brackets are not used for a four-post rack, and must be removed from the chassis. To remove the center-mounting brackets from the chassis: 1. Loosen the screws from each br ...