Gira 5431 00 Operating Instructions Manual

Wireless dimming actuator, 4-gang Order no.: 5431 00 Operating instructions 1 Safety instructions Electrical devices may only be mounted and connected by electrically skilled persons. Serious injuries, fire or property damage possible. Please read and follow manual fully. Danger of electric shock. Always disconnect before ca ...

– Switch-off warning – Operation locks – Continuous on, Continuous off – Hotel function – Run-on time – Light control Supplementary functions with eNet Server: – Fully encrypted radio transmission (AES-CCM) from eNet Server software version 2.0 – Update of the device software – Reading of error memory Behav ...

Fitting the device Observe the temperature range. Ensure adequate cooling. Maintain a distance of 18 mm (1 module) between the devices when operating multiple dimmers or power units within a sub-division. ￭ Mount device on DIN rail. Output terminals must be at the top. Connect bus line Figure 1: Connection diagram of bus ...

Connecting loads to outputs Figure 2: Connection example of outputs (1) Load connection A1...A4 (2) Operating mode switch A1...A4 (3) Button Prog A1...A4 (4) Status LED A1...A4 (5) Switch Mod. (6) Bus line connection ￭ Set Mod. switch (5) to position 1. All load outputs work independently of each other. Connect 600 Watt L ...

Switching outputs in parallel Two to four load outputs can be switched in parallel for the power booster. The output with the lowest number is the master output, the allocated outputs work as slave. The operation, setting of the operating mode, basic brightness, switch-on brightness and parameters takes place only on the mas ...

Figure 4: Connection example with two parallel outputs each Do not connect any LED lamps or compact fluorescent lamps to outputs switched in par- allel. Do not connect electronic and inductive Transformers together to outputs switched in par- allel. ￭ Connect loads as shown in the wiring example (Figure 4). Presetting the ...

Switch position Function/connectable loads ciple, dimmable HV-LED or compact fluorescent lamps that can be dimmed according to the trailing edge phase control principle. The connection of inductive transformers is not per- mitted. min. Setting of the minimum brightness *) If the operating mode switch is turned from the posit ...

The status LED (4) flashes quickly for 5 seconds. The output is disconnected from the ra- dio transmitter. The output and radio transmitter exit the programming mode automatic- ally. If there several connections or scene buttons for a radio transmitter, all connections must be disconnected individually. All On and All Off bu ...

For ohmic-inductive mixed load, maximum 50% proportion of ohmic load. Otherwise in- correct calibration of the dimmer may result. Only subject load outputs switched in parallel to up to 95%. The minimum load of parallel switching of load outputs is 250 VA. Figure 6: Connected load If the operating mode is set to HV { LED tr ...

Parameters Setting options, Basic setting Explanations Operating mode Normal operation Continuous on Continuous off Basic setting: Normal Opera- tion Normal operation The output can be operated with radio transmitters and the Prog button. Continuous on The output switches to con- tinuously "On". All operations of radio trans ...