Danfoss MCO 351 Technical Data Manual

3 Approvals 3 Symbols 3 High Voltage 4 Safety Instructions 4 Avoid Unintended Start 5 Safe Stop of FC 300 5 Safe Stop Installation (FC 302 and FC 301 - A1 enclosure only) 7 IT Mains 7 2. Introduction 9 Hardware 9 VLT Control Card Terminals 9 Technical Data 9 Introduction 9 Option Card Terminals 9 Encoder Monitor 10 Option Card L ...

39 Setting par. 32-81 and 19-06 39 Other Settings 40 6. Troubleshooting 41 Frequently Asked questions 41 Error Messages 42 Glossary of Key Terms 44 Index 47 Contents MCO351 Positioning Controller 2 MG.33.R1.02 - VLT® is a registered Danfoss trademark ...

1.1.1. Approvals 1.1.2. Symbols Symbols used in these Operating Instructions. NB! Indicates something to be noted by the reader. Indicates a general warning. Indicates a high-voltage warning. ∗ Indicates default setting 1.1.3. Disposal Instruction Equipment containing electrical components may not be disposed of together with domestic ...

0.25 - 7.5 kW 4 minutes 11 - 75 kW 15 minutes 90 - 200 kW 20 minutes 250 - 400 kW 40 minutes 525 - 690 V 37 - 250 kW 20 minutes 315 - 560 kW 30 minutes MCO 351 Positioning Controller for VLT AutomationDrive FC 30x Operating Instructions Software version: 1.1x These Operating Instructions can be used for all MCO 351 Positioning Controller f ...

Warning: Touching the electrical parts may be fatal - even after the equipment has been dis- connected from mains. Also make sure that other voltage inputs have been disconnected, such as load- sharing (linkage of DC intermediate circuit), as well as the motor connection for kinetic back-up. Using VLT® AutomationDrive FC 300: wait at ...

functionality is called Safe Stop. Prior to integration and use of Safe Stop in an installation, a thorough risk analysis on the installation must be carried out in order to determine whether the Safe Stop functionality and safety category are appropriate and suf ...

To carry out an installation of a Catego- ry 0 Stop (EN60204) in conformance with Safety Category 3 (EN954-1), fol- low these instructions: 1. The bridge (jumper) between Termi- nal 37 and 24 V DC must be re- moved. Cutting or breaking the jumper is not sufficient. Remove it entirely to a ...

8 MG.33.R1.02 - VLT® is a registered Danfoss trademark 2 ...

The terminals on the control card are allocated for positioning controller functions the following parameter settings should therefore not be changed in synchronising mode (set-up 1): Digital inputs 18, 19, 27, 32 and 33 Parameters 510–515 are set to No operation (default setting), then the in ...

Terminal X57 Terminal Number Descriptive Name Digital Inputs 1 Digital Input 2 Digital Input 3 Digital Input 4 Digital Input 5 Digital Input 6 Digital Input 7 Digital Input 8 Digital Input 9 Digital Input 10 Digital Input Terminal X59 Terminal Number Descriptive Nam ...